HP Smart array P440 support

[Mark Saad]

All
Also don't forget to is install cciss_vol_status to monitor the array .

---
Mark Saad | nonesuch at longcount.org

On Sep 2, 2017, at 11:41 AM, sthaug at nethelp.no wrote:

>>> I have HP DL20 Gen 9 server. But I can not install FreeBSD 10.2 in it. I
>>> have a HP smart array P440 in my server. I can not find out anywhere if ciss
>>> driver support include HP Gen 9 storage controllers.  Could you please
>>> update the ciss driver in 10.3?
>> 
>> Try 10.3
>> 
>> I know the release-notes say nothing about it, but I believe it is supported.
>> 
>> If not that, 11.0 surely does (even though the release-notes don$,1ry(Bt mention it, either)
> 
> I can confirm that 10.3 supports the P440 controller. From a DL360 Gen9
> server running 10.3 here:
> 
> ciss0: <HP Smart Array P440ar> port 0x2000-0x20ff mem 0x92c00000-0x92cfffff,0x92d00000-0x92d003ff irq 16 at device 0.0 on pci3
> ciss0: PERFORMANT Transport
> ...
> da0 at ciss0 bus 0 scbus0 target 0 lun 0
> da0: <HP RAID 1(1+0) OK> Fixed Direct Access SPC-3 SCSI device
> da0: Serial Number PDNLH0BRH8S3RF
> da0: 135.168MB/s transfers
> da0: Command Queueing enabled
> da0: 139979MB (286677120 512 byte sectors)
> 
> Steinar Haug, Nethelp consulting, sthaug at nethelp.no
> _______________________________________________
> freebsd-stable at freebsd.org mailing list
> https://lists.freebsd.org/mailman/listinfo/freebsd-stable
> To unsubscribe, send any mail to "freebsd-stable-unsubscribe at freebsd.org"