arge1 on TL WDR3600

[Adrian Chadd]

It's one of those unclear things - there's no port0 MII/PHY. port1 ==
phy0, port2 == phy1, etc.


-a


On 26 October 2015 at 06:52, Eugene Grosbein <eugen at grosbein.net> wrote:
> On 26.10.2015 00:39, Adrian Chadd wrote:
>> Hi,
>>
>> I'll try to answer more thoroughly tomorrow, but in the meanwhile:
>
> [skip]
>
> Thank you very much for explanation.
>
> Another thing: when I insert cable into "WAN" port, kernel writes to console:
>
> arswitch0: arswitch_miipollstat: port 0: port -> UP
>
> But then, etherswitchcfg command shows "status: active" for port 1
> having no flags and port 0 is CPUPORT:
>
> etherswitch0: VLAN mode: DOT1Q
> port0:
>         pvid: 1
>         flags=1<CPUPORT>
>         media: Ethernet 1000baseT <full-duplex>
>         status: active
> port1:
>         pvid: 1
>         flags=0<>
>         media: Ethernet autoselect (1000baseT <full-duplex>)
>         status: active
>
> Isn't it off-by-one error in the arswitch diagnostics output?
>