Intro Centrino 2000 firmware error

[Eitan Adler]

With Adrian's latest patch:

I am able to create wlan1 based on iwn0

iwn0 at pci0:2:0:0:        class=0x028000 card=0x42228086 chip=0x08918086
rev=0xc4 hdr=0x00
    vendor     = 'Intel Corporation'
    device     = 'Centrino Wireless-N 2200'
    class      = network

However attempting to do wpa_supplicant (even for an open network)
results in the following:

iwn0: iwn_intr: fatal firmware error
firmware error log:
  error type      = "UNKNOWN" (0x00002776)
  program counter = 0x00009348
  source line     = 0x00000067
  error data      = 0x0408008000000002
  branch link     = 0x0000933600009336
  interrupt link  = 0x0000E1AE00000000
  time            = 29752
driver status:
  tx ring  0: qid=0  cur=0   queued=0
  tx ring  1: qid=1  cur=0   queued=0
  tx ring  2: qid=2  cur=0   queued=0
  tx ring  3: qid=3  cur=0   queued=0
  tx ring  4: qid=4  cur=9   queued=0
  tx ring  5: qid=5  cur=0   queued=0
  tx ring  6: qid=6  cur=0   queued=0
  tx ring  7: qid=7  cur=0   queued=0
  tx ring  8: qid=8  cur=0   queued=0
  tx ring  9: qid=9  cur=0   queued=0
  tx ring 10: qid=10 cur=0   queued=0
  tx ring 11: qid=11 cur=0   queued=0
  tx ring 12: qid=12 cur=0   queued=0
  tx ring 13: qid=13 cur=0   queued=0
  tx ring 14: qid=14 cur=0   queued=0
  tx ring 15: qid=15 cur=0   queued=0
  tx ring 16: qid=16 cur=0   queued=0
  tx ring 17: qid=17 cur=0   queued=0
  tx ring 18: qid=18 cur=0   queued=0
  tx ring 19: qid=19 cur=0   queued=0
  rx ring: cur=9



-- 
Eitan Adler