Odd issue with ath and 2 IPs on interface at boot

[Vincent Hoffman]

That makes sense. I just added a couple of lines to rc.local for now.
will update/test again in a month or so.
The other option I thought might work would be to make 2 nodes from the
ath0, wlan0 (station mode) and wlan1 (access point) and have the inside
addresses on a separate network, might try that later.

Vince

On 06/11/2013 23:22, Adrian Chadd wrote:
> There's bugs with how interfaces are setup and wpa_supplicant is being
> called. So I think this is just fallout from that.
>
>
> :(
>
>
> -adrian
>
>
> On 6 November 2013 15:20, Vincent Hoffman <vince at unsane.co.uk> wrote:
>> Hi,
>>     I'm trying to bring up a wlan interface with 2 IPs on it so I can
>> NAT other devices on the wireless network.
>> If I try and configure both IPs at boot via rc.conf I get no link and
>> logs as follows
>> Many repeating
>> Nov  5 23:02:34 ostracod wpa_supplicant[676]: wlan0: Failed to initiate
>> AP scan
>> Nov  5 23:02:35 ostracod kernel: ath0: ath_legacy_rx_tasklet:
>> sc_inreset_cnt > 0; skipping
>> Nov  5 23:02:35 ostracod wpa_supplicant[676]: ioctl[SIOCS80211, op=103,
>> val=0, arg_len=128]: Operation now in progress
>> Nov  5 23:02:35 ostracod wpa_supplicant[676]: wlan0: Failed to initiate
>> AP scan
>> with the occasional
>> Nov  5 23:04:51 ostracod kernel: ath0: ath_raw_xmit: sc_inreset_cnt > 0;
>> bailing
>> Nov  5 23:04:51 ostracod kernel: ath0: ath_raw_xmit: sc_inreset_cnt > 0;
>> bailing
>>
>> in rc.conf I have:
>>    wlans_ath0="wlan0"
>>    ifconfig_wlan0="WPA inet 85.233.185.162/29 -bgscan"
>>    ifconfig_wlan0_alias0="inet 10.10.10.1/24"
>>
>>
>> If however I add just one address and then create the alias manually
>> later It works fine.
>>
>> ath device details
>>
>> ath0: <Atheros 5424/2424> mem 0xfebf0000-0xfebfffff irq 16 at device 0.0
>> on pci4
>> ath0: AR2425 mac 14.2 RF5424 phy 7.0
>> ath0: 2GHz radio: 0x0000; 5GHz radio: 0x00a2
>>
>> ath0 at pci0:4:0:0:        class=0x020000 card=0x7131144f chip=0x001c168c
>> rev=0x01 hdr=0x00
>>     vendor     = 'Atheros Communications Inc.'
>>     device     = 'AR242x / AR542x Wireless Network Adapter (PCI-Express)'
>>     class      = network
>>     subclass   = ethernet
>>
>> OS details:
>> FreeBSD ostracod.unsane.co.uk 10.0-BETA2 FreeBSD 10.0-BETA2 #71 r257498:
>> Fri Nov  1 17:31:01 GMT 2013
>> toor at ostracod.unsane.co.uk:/scratch/obj/usr/src/sys/OSTRACOD  amd64
>>
>> It seems unlikely this is expected and i'm not even sure its ath based
>> but I dont have any other wireless interfaces to test with.
>> Any suggestions?
>> The system is in use at the moment but I can test from time to time.
>>
>> Vince
>>
>>
>> _______________________________________________
>> freebsd-wireless at freebsd.org mailing list
>> http://lists.freebsd.org/mailman/listinfo/freebsd-wireless
>> To unsubscribe, send any mail to "freebsd-wireless-unsubscribe at freebsd.org"