SETFEATURES SET TRANSFER MODE semaphore timeout on FreeBSD 6.0 RELEASE

[Nikolay Pavlov]

On Friday, 17 March 2006 at 22:13:05 +0100, Wilko Bulte wrote:
> On Fri, Mar 17, 2006 at 03:35:39PM -0500, Kris Kennaway wrote..
> > On Fri, Mar 17, 2006 at 03:03:27PM -0500, Mike Tancsa wrote:
> > > At 01:34 PM 17/03/2006, Peter van Heusden wrote:
> > > >Ok, but the machine is not stable enough to run cvsup / buildworld on. I
> > > >guess I need to do a binary install of one of the FreeBSD 6.1 betas.
> > > >Thanks for the advice.
> > > 
> > > 
> > > You might be able to just grab the kernel off a newer Beta and 
> > > install the kernel on your machine and boot from it.  Then do your 
> > > cvsup / buildworld/kernel.
> > 
> > Or just boot in 'safe mode' (i.e. don't use DMA).
> 
> Did not help for me at the time.

I guess it's a maxtor drive and on PIO mode you'll only see the same error, 
but something about OTHER MODE (don't remember now) It's only helps me when 
i have canged the drive to WD.

> 
> -- 
> Wilko Bulte				wilko at FreeBSD.org
> _______________________________________________
> freebsd-stable at freebsd.org mailing list
> http://lists.freebsd.org/mailman/listinfo/freebsd-stable
> To unsubscribe, send any mail to "freebsd-stable-unsubscribe at freebsd.org"

-- 
============================================================================
= Best regards, Nikolay Pavlov. <<<--------------------------------------- =
============================================================================