6.x stable

[Stephen Clark]

Hi list,

I thought this device was supported:

   The nve(4) driver supports the NVIDIA MCP onboard adapters of
   mainboards with the following chipsets:

     * nForce

     * nForce2

     * nForce3

     * nForce4

Mother board with
NVIDIA® GeForce6100 + nForce 410

from lspci -vv:
00:14.0 Bridge: nVidia Corporation MCP51 Ethernet Controller (rev a1)
        Subsystem: Biostar Microtech Int'l Corp Unknown device 2501
        Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- 
ParErr- Stepping- SERR- FastB2B-
        Status: Cap+ 66MHz+ UDF- FastB2B+ ParErr- DEVSEL=fast >TAbort- 
<TAbort- <MAbort- >SERR- <PERR-
        Latency: 0 (250ns min, 5000ns max)
        Interrupt: pin A routed to IRQ 22
        Region 0: Memory at fe02d000 (32-bit, non-prefetchable)
        Region 1: I/O ports at dc00
        Capabilities: [44] Power Management version 2
                Flags: PMEClk- DSI- D1+ D2+ AuxCurrent=0mA 
PME(D0+,D1+,D2+,D3hot+,D3cold+)
                Status: D0 PME-Enable- DSel=0 DScale=0 PME-

But I don't get a device to ifconfig?

Thanks in advance.
Steve

-- 

"They that give up essential liberty to obtain temporary safety, 
deserve neither liberty nor safety."  (Ben Franklin)

"The course of history shows that as a government grows, liberty 
decreases."  (Thomas Jefferson)