fdc init fail with ACPI enabled
Igor Pokrovsky
ip at doom.homeunix.org
Sun Mar 6 10:01:54 PST 2005
Hi,
When building kernel with both acpica and fdc at boot time I'm getting:
fdc0: cannot reserve I/O port range
Without acpica compiled into kernel fdc detects perfectly fine.
fdc is defined in kernel config as follows (same as in GENERIC):
device fdc0 at isa? port IO_FD1 irq 6 drq 2
device fd0 at fdc0 drive 0
Probably I should specify different port range for fdc...
In this case what range? Any ideas?
P.S. 4.11-STABLE i386 FreeBSD built on Sun Mar 6 18:38:35 MSK 2005.
-ip
--
After all is said and done, a hell of a lot more is said
than done
More information about the freebsd-stable
mailing list