RELENG_5 problems with Intel 855 (RELENG_4 boots fine) (solved!)

Mike Tancsa mike at
Fri Apr 1 11:00:40 PST 2005

At 01:29 PM 01/04/2005, Gray Lilley wrote:
>Can you try setting hw.pci.enable_io_modes=0 at the loader prompt then 

Thanks!  That did the trick!!

OK set hw.pci.enable_io_modes=0
OK boot
/boot/kernel/acpi.ko text=0x41520 data=0x1da4+0x112c 
KDB: debugger backends: ddb
KDB: current backend: ddb
Copyright (c) 1992-2005 The FreeBSD Project.
Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
         The Regents of the University of California. All rights reserved.
FreeBSD 5.4-PRERELEASE #0: Fri Apr  1 09:06:22 EST 2005
     mdtancsa at
Timecounter "i8254" frequency 1193182 Hz quality 0
CPU: Intel(R) Celeron(R) M processor         1500MHz (1500.06-MHz 686-class 
   Origin = "GenuineIntel"  Id = 0x695  Stepping = 5
real memory  = 534642688 (509 MB)
avail memory = 513507328 (489 MB)
ioapic0 <Version 2.0> irqs 0-23 on motherboard
npx0: <math processor> on motherboard
npx0: INT 16 interface
acpi0: <AOpen AWRDACPI> on motherboard
acpi0: Power Button (fixed)
Timecounter "ACPI-fast" frequency 3579545 Hz quality 1000
acpi_timer0: <24-bit timer at 3.579545MHz> port 0x4008-0x400b on acpi0
cpu0: <ACPI CPU (3 Cx states)> on acpi0
acpi_throttle0: <ACPI CPU Throttling> on cpu0
acpi_button0: <Power Button> on acpi0
acpi_button1: <Sleep Button> on acpi0
pcib0: <ACPI Host-PCI bridge> port 0xcf8-0xcff on acpi0
pci0: <ACPI PCI bus> on pcib0
pci0: <base peripheral> at device 0.1 (no driver attached)
pci0: <base peripheral> at device 0.3 (no driver attached)
pcib1: <PCI-PCI bridge> at device 1.0 on pci0
pci1: <PCI bus> on pcib1
agp0: <Intel 82855GME (855GME GMCH) SVGA controller> port 0xe300-0xe307 mem 
0xed000000-0xed07ffff,0xe0000000-0xe7ffffff irq 16 at device 2.0 on pci0
agp0: detected 892k stolen memory
agp0: aperture size is 128M
pci0: <display> at device 2.1 (no driver attached)
pcib2: <ACPI PCI-PCI bridge> at device 30.0 on pci0
pci2: <ACPI PCI bus> on pcib2
puc0: <Lava Computers Quattro-PCI serial port> port 
0xd300-0xd307,0xd200-0xd207 irq 16 at device 4.0 on pci2
sio4: <Lava Computers Quattro-PCI serial port> on puc0
sio4: type 16550A
sio4: unable to activate interrupt in fast mode - using normal mode
sio5: <Lava Computers Quattro-PCI serial port> on puc0
sio5: type 16550A
sio5: unable to activate interrupt in fast mode - using normal mode
puc1: <Lava Computers Quattro-PCI serial port> port 
0xd500-0xd507,0xd400-0xd407 irq 16 at device 4.1 on pci2
sio6: <Lava Computers Quattro-PCI serial port> on puc1
sio6: type 16550A
sio6: unable to activate interrupt in fast mode - using normal mode
sio7: <Lava Computers Quattro-PCI serial port> on puc1
sio7: type 16550A
sio7: unable to activate interrupt in fast mode - using normal mode
pci2: <simple comms, UART> at device 5.0 (no driver attached)
twe0: <3ware Storage Controller. Driver version> port 
0xd700-0xd70f mem 0xec000000-0xec7fffff irq 18 at device 6.0 on pci2
twe0: 2 ports, Firmware FE7X, BIOS BE7X
isab0: <PCI-ISA bridge> at device 31.0 on pci0
isa0: <ISA bus> on isab0
atapci0: <Intel ICH4 UDMA100 controller> port 
0xf000-0xf00f,0x376,0x170-0x177,0x3f6,0x1f0-0x1f7 at device 31.1 on pci0
ata0: channel #0 on atapci0
ata1: channel #1 on atapci0
pci0: <serial bus, SMBus> at device 31.3 (no driver attached)
acpi_tz0: <Thermal Zone> on acpi0
fdc0: <floppy drive controller> port 0x3f7,0x3f0-0x3f5 irq 6 drq 2 on acpi0
sio0: <16550A-compatible COM port> port 0x3f8-0x3ff irq 4 flags 0x10 on acpi0
sio0: type 16550A, console
sio1: <16550A-compatible COM port> port 0x2f8-0x2ff irq 3 on acpi0
sio1: type 16550A
atkbdc0: <Keyboard controller (i8042)> port 0x64,0x60 irq 1 on acpi0
atkbd0: <AT Keyboard> irq 1 on atkbdc0
kbd0 at atkbd0
pmtimer0 on isa0
orm0: <ISA Option ROM> at iomem 0xd0000-0xd0fff on isa0
sc0: <System console> at flags 0x100 on isa0
sc0: VGA <16 virtual consoles, flags=0x300>
vga0: <Generic ISA VGA> at port 0x3c0-0x3df iomem 0xa0000-0xbffff on isa0
ppc0: parallel port not found.
Timecounter "TSC" frequency 1500059900 Hz quality 800
Timecounters tick every 10.000 msec
ipfw2 initialized, divert enabled, rule-based forwarding enabled, default 
to accept, logging limited to 3100 packets/entry by default
ad0: 38166MB <ST340014A/3.06> [77545/16/63] at ata0-master UDMA100
acd0: CDROM <CD-ROM 48X/AKU/T31> at ata1-master PIO4
twed0: <Unit 0, TwinStor, Normal> on twe0
twed0: 76318MB (156299440 sectors)
Mounting root from ufs:/dev/ad0s1a
Pre-seeding PRNG: kickstart.
Loading configuration files.
Entropy harvesting: interrupts ethernet point_to_point kickstart.
kernel dumps on /dev/ad0s1b
swapon: adding /dev/ad0s1b as swap device
Starting file system checks:
/dev/ad0s1a: clean, 331086 free (990 frags, 41262 blocks, 0.2% fragmentation)
/dev/ad0s1e: clean, 500291 free (203 frags, 62511 blocks, 0.0% fragmentation)
/dev/ad0s1d: clean, 6260810 free (48418 frags, 776549 blocks, 0.6% 
/dev/ad0s1f: clean, 9698700 free (252 frags, 1212306 blocks, 0.0% 
Setting hostname:
lo0: flags=8049<UP,LOOPBACK,RUNNING,MULTICAST> mtu 16384
         inet netmask 0xff000000
Flushed all rules.
00100 allow ip from any to any via lo0
00200 deny ip from any to
00300 deny ip from to any
65000 allow ip from any to any
Firewall rules loaded, starting divert daemons:.
Firewall logging enabled
net.inet.ip.fw.enable: 1 -> 1
Additional routing options:.
Starting devd.
Mounting NFS file systems:.
Starting syslogd.
Apr  1 12:07:52 nfs syslogd: kernel boot file is /boot/kernel/kernel 

More information about the freebsd-stable mailing list