sil 0680 RAID 1

[Chris Howells]

-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1

Hi,

On Tuesday 25 November 2003 10:49, Bognár Zsolt wrote:
> I  purchased a Sil680 IDE RAID controller, and have setup a mirrored RAID
> array.
> My problem is, FreeBSD 4.8 and 4.9 GENERIC does not recognize them as one
> disk.
> I checked the hardware notes, and "Sil680 UDMA6" is listed.

That could mean that it works as a standard IDE controller, not necessarily as 
a RAID controller.

> I have one ad4 and one ad6 disk. (I can see same partition and data on both
> of them)
> Finally, the mirroring works fine but if the ad4 disk goes wrong, the BSD
> can't mount the root disk from ad6.(boot is OK)
>
> Is there anyway to get the FreeBSD to recognize my RAID array?

Not too much help I'm afraid, but I wasn't confident in the abilities of such
a cheap controller (mine cost me GBP £20, about USD $30) to work well,
particularly with FreeBSD. I just set mine into "standard IDE contoller" mode
(there was a jumper on the board to control this), and have set up a mirrored
RAID 1 with vinum.

So far it's running fine like this.

- --
Cheers, Chris Howells -- chris at chrishowells.co.uk, howells at kde.org
Web: http://chrishowells.co.uk, PGP ID: 0x33795A2C
KDE/Qt/C++/PHP Developer: http://www.kde.org
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.2.3 (FreeBSD)

iD8DBQE/w1oPF8Iu1zN5WiwRAs1SAKCnDDGkdTan9XhMPRewuIF4mArmBwCfQdDZ
jXGIawKPy/aLSK7kT6has8k=
=yBw/
-----END PGP SIGNATURE-----