[sun] Booting problem with Sun Enterprise 220R

Thu May 10 08:22:37 UTC 2007

Hi Matthew,

nop I cant at time because the server is far away .. :)
yes I think it is a PCI Card.

Regards,
Ronan Kerambrun

Matthew Jacob a écrit :
> Ouch. That means that it dies in register mapping. This chip is on a
> PCI card? Can you pull it and install on another disk?
>
> On 5/9/07, ronan <ron at artful.net> wrote:
>> Hi Matthew,
>>
>> I already have tried both but it dont work.
>> load ispfw or set hint.isp.0.disable=1
>>
>> -------------------------------------------
>> OK load ispfw
>> OK boot
>> nothing to autoload yet.
>> jumping to kernel entry at 0xc0060000.
>> stray vector interrupt 2029
>> Copyright (c) 1992-2007 The FreeBSD Project.
>> Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
>>        The Regents of the University of California. All rights reserved.
>> FreeBSD is a registered trademark of The FreeBSD Foundation.
>> FreeBSD 6.2-STABLE-200704 #0: Mon Apr  2 16:12:13 UTC 2007
>> ...
>> ...
>> pci0: <serial bus, Fibre Channel> at device 2.0 (no driver attached)
>> pcib1: <OFW PCI-PCI bridge> at device 4.0 on pci0
>> pci1: <OFW PCI bus> on pcib1
>> isp0: <Qlogic ISP 10160 PCI SCSI Adapter> port 0x1000-0x10ff mem
>> 0x100000-0x100fff at device 4.0 on pci1
>> isp0: [GIANT-LOCKED]
>> panic: trap: data access error
>> cpuid = 0
>> Uptime: 1s
>> Automatic reboot in 15 seconds - press a key on the console to abort
>>
>> ---------------------------------------------
>>
>> Do you think there is any way to use FreeBSD on this server ?
>> Thank you for your help,
>>
>> Best regards,
>> ronan.
>>
>>
>> Matthew Jacob a écrit :
>> > Yuck- this is the 10160 Ultra-160 part I've never actually seen. Does
>> > the 6.2 bootonly iso have the ispfw module? That is, can you stup the
>> > boot and do
>> >
>> > load ispfw
>> >
>> > and continue along and does that help? I suspect it probably doesn't
>> > and I might h ave to do some work to get this supported. If your disks
>> > are off of sym instead of isp, you can also do
>> >
>> > set hint.isp.0.disable=1
>> >
>> > so you can get installed at least.
>> >
>> > Let me know how this one goes.
>> >
>> > On 5/7/07, ronan <ron at artful.net> wrote:
>> >> Hi all,
>> >>
>> >> I am trying to install from 6.2-STABLE-200704-sparc64-bootonly.iso
>> >> 
>> <ftp://ftp.freebsd.org/pub/FreeBSD/snapshots/200704/6.2-STABLE-200704-sparc64-bootonly.iso> 
>>
>> >>
>> >> (it is the same from the 7.0 CURRENT snapshot)
>> >> But I cant, it crash during booting the kernel. Here is the boot 
>> log :
>> >>
>> >> 
>> ------------------------------------------------------------------------- 
>>
>> >>
>> >>
>> >> Ethernet address 8:0:20:xx:xx:xx, Host ID: 80c823eb.
>> >>
>> >>
>> >>
>> >> Rebooting with command: boot /pci at 1f,4000/scsi at 3/disk at 6,0:f
>> >> Boot device: /pci at 1f,4000/scsi at 3/disk at 6,0:f  File and args:
>> >>
>> >>  >> FreeBSD/sparc64 boot block
>> >>   Boot path:   /pci at 1f,4000/scsi at 3/disk at 6,0:f
>> >>   Boot loader: /boot/loader
>> >> Consoles: Open Firmware console
>> >> Boot path set to /pci at 1f,4000/scsi at 3/disk at 6,0:a
>> >>
>> >> FreeBSD/sparc64 bootstrap loader, Revision 1.0
>> >> (root at edmunds.cse.buffalo.edu, Mon Apr  2 00:37:48 UTC 2007)
>> >> bootpath="/pci at 1f,4000/scsi at 3/disk at 6,0:a"
>> >> Loading /boot/defaults/loader.conf
>> >> /boot/kernel/kernel data=0x56f408+0x5bfa8 
>> syms=[0x8+0x6d7b8+0x8+0x5b032]
>> >> -
>> >> Hit [Enter] to boot immediately, or any other key for command prompt.
>> >> Booting [/boot/kernel/kernel]...
>> >> nothing to autoload yet.
>> >> jumping to kernel entry at 0xc0060000.
>> >> stray vector interrupt 2029
>> >> Copyright (c) 1992-2007 The FreeBSD Project.
>> >> Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 
>> 1993, 1994
>> >>        The Regents of the University of California. All rights 
>> reserved.
>> >> FreeBSD is a registered trademark of The FreeBSD Foundation.
>> >> FreeBSD 6.2-STABLE-200704 #0: Mon Apr  2 16:12:13 UTC 2007
>> >>    root at edmunds.cse.buffalo.edu:/usr/obj/usr/src/sys/GENERIC
>> >> real memory  = 2147483648 (2048 MB)
>> >> avail memory = 2063147008 (1967 MB)
>> >> cpu0: Sun Microsystems UltraSparc-II Processor (450.05 MHz CPU)
>> >> cpu1: Sun Microsystems UltraSparc-II Processor (450.05 MHz CPU)
>> >> FreeBSD/SMP: Multiprocessor System Detected: 2 CPUs
>> >> ath_hal: 0.9.20.3 (AR5210, AR5211, AR5212, RF5111, RF5112, RF2413,
>> >> RF5413, REGOPS_FUNC)
>> >> nexus0: <Open Firmware Nexus device>
>> >> pcib0: <U2P UPA-PCI bridge> on nexus0
>> >> pcib0: Psycho, impl 0, version 4, ign 0x7c0, bus B
>> >> pcib0: [FAST]
>> >> pcib0: [FAST]
>> >> pcib0: [GIANT-LOCKED]
>> >> pcib0: [GIANT-LOCKED]
>> >> pcib0: [FAST]
>> >> initializing counter-timer
>> >> Timecounter "counter-timer" frequency 1000000 Hz quality 100
>> >> pcib0 dvma: DVMA map: 0xfc000000 to 0xffffffff
>> >> pci0: <OFW PCI bus> on pcib0
>> >> ebus0: <PCI-EBus2 bridge> mem
>> >> 0x70000000-0x70ffffff,0x71000000-0x717fffff at device 1.0 on pci0
>> >> auxio0: <Sun Auxiliary I/O> addr
>> >> 
>> 0x1400726000-0x1400726003,0x1400728000-0x1400728003,0x140072a000-0x140072a003,0x140072c000-0x140072c003,0x140072f000-0x140072f003 
>>
>> >>
>> >> on ebus0
>> >> ebus0: <power> addr 0x1400724000-0x1400724003 (no driver attached)
>> >> ebus0: <SUNW,pll> addr 0x1400504000-0x1400504002 (no driver attached)
>> >> ebus0: <sc> addr 0x1400500000-0x1400500007 (no driver attached)
>> >> puc0: <Siemens SAB 82532 dual channel SCC> addr
>> >> 0x1400400000-0x140040007f irq 43 on ebus0
>> >> uart0: <SAB 82532 v3.2, channel A> on puc0
>> >> uart0: CTS oflow
>> >> uart0: console (9600,n,8,1)
>> >> uart1: <SAB 82532 v3.2, channel B> on puc0
>> >> uart1: CTS oflow
>> >> uart2: <16550 or compatible> addr 0x14003083f8-0x14003083ff irq 41 on
>> >> ebus0
>> >> uart2: keyboard (1200,n,8,1)
>> >> uart2: keyboard not present
>> >> uart3: <16550 or compatible> addr 0x14003062f8-0x14003062ff irq 42 on
>> >> ebus0
>> >> ebus0: <ecpp> addr
>> >> 
>> 0x14003043bc-0x14003043cb,0x1400300398-0x1400300399,0x1400700000-0x140070000f 
>>
>> >>
>> >> irq 34 (no driver attached)
>> >> ebus0: <fdthree> addr
>> >> 
>> 0x14003023f0-0x14003023f7,0x1400706000-0x140070600f,0x1400720000-0x1400720003 
>>
>> >>
>> >> irq 39 (no driver attached)
>> >> eeprom0: <EEPROM/clock> addr 0x1400000000-0x1400001fff on ebus0
>> >> eeprom0: model mk48t59
>> >> eeprom0: hostid 80c823eb
>> >> ebus0: <flashprom> addr 0x1000000000-0x10000fffff (no driver 
>> attached)
>> >> hme0: <Sun HME 10/100 Ethernet> mem 0x500000-0x507fff at device 1.1
>> >> on pci0
>> >> miibus0: <MII bus> on hme0
>> >> ukphy0: <Generic IEEE 802.3u media interface> on miibus0
>> >> ukphy0:  10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
>> >> hme0: Ethernet address: 08:00:20:c8:23:eb
>> >> sym0: <875> port 0x2000-0x20ff mem 
>> 0x508000-0x5080ff,0x50a000-0x50afff
>> >> at device 3.0 on pci0
>> >> sym0: No NVRAM, ID 7, Fast-20, SE, parity checking
>> >> sym0: [GIANT-LOCKED]
>> >> sym1: <875> port 0x2400-0x24ff mem 
>> 0x50c000-0x50c0ff,0x50e000-0x50efff
>> >> at device 3.1 on pci0
>> >> sym1: No NVRAM, ID 7, Fast-20, SE, parity checking
>> >> sym1: [GIANT-LOCKED]
>> >> pci0: <serial bus, Fibre Channel> at device 2.0 (no driver attached)
>> >> pcib1: <OFW PCI-PCI bridge> at device 4.0 on pci0
>> >> pci1: <OFW PCI bus> on pcib1
>> >> isp0: <Qlogic ISP 10160 PCI SCSI Adapter> port 0x1000-0x10ff mem
>> >> 0x100000-0x100fff at device 4.0 on pci1
>> >> isp0: [GIANT-LOCKED]
>> >> panic: trap: data access error
>> >> cpuid = 0
>> >> Uptime: 1s
>> >> Automatic reboot in 15 seconds - press a key on the console to abort
>> >>
>> >> 
>> ------------------------------------------------------------------------- 
>>
>> >>
>> >>
>> >> Is there any solution ? Is it a compatibility problem with the Qlogic
>> >> ISP 10160 ?
>> >>
>> >> Best regards,
>> >>
>> >> ronan.
>> >>
>> >> _______________________________________________
>> >> freebsd-sparc64 at freebsd.org mailing list
>> >> http://lists.freebsd.org/mailman/listinfo/freebsd-sparc64
>> >> To unsubscribe, send any mail to
>> >> "freebsd-sparc64-unsubscribe at freebsd.org"
>> >>
>> >
>> >
>> _______________________________________________
>> freebsd-sparc64 at freebsd.org mailing list
>> http://lists.freebsd.org/mailman/listinfo/freebsd-sparc64
>> To unsubscribe, send any mail to 
>> "freebsd-sparc64-unsubscribe at freebsd.org"
>>
>
>

-- 
-------------------------------------------------------------
*Ronan Kerambrun*
*Administrateur Systèmes / Réseaux*

*Artful*
5 avenue des peupliers - 35510 Cesson Sévigné
tél : +33 2 99 125 757 - fax : +33 2 99 125 758
www.artful.net <http://www.artful.net>

a claranet company <http://www.clara.net/>