very slow - WCPU
Pete Wright
pete at nomadlogic.org
Thu Jun 18 00:20:02 UTC 2020
On 6/17/20 4:44 PM, ajtiM via freebsd-questions wrote:
> Hi!
>
> For whatever reason after few last updates I cannot use FreeCAD (WCPU
> 99,7%), Cura (3D printing) - WCPU time is good for cura-engine but
> Python 3.7 is 100.22% and Blender stop working because "Error!
> Unsupported graphics card or driver. A graphics card and driver with
> support for OpenGL 3.3 or higher is required. The program will now
> close."
Can you provide information on which graphics card you are using, and if
you have installed/configured the appropriate drivers? That will most
likely help people here better answer you question.
cheers,
-pete
--
Pete Wright
pete at nomadlogic.org
@nomadlogicLA
More information about the freebsd-questions
mailing list