No sound from speaker, using Realtek ALC269 and snd_hda

[Alexander Motin]

On 28.10.2012 23:20, Big Yuuta wrote:
> Unfortunately, trying with the different combinations didn't work.
>
> I wrote this tiny script just to make sure I'm not forgetting a case:
>
> #!/bin/sh
> echo "testing with: $1 - $2";
> kenv hint.hdaa.0.gpio_config="0=$1 1=$2";
> kldunload snd_hda.ko;
> kldload snd_hda.ko;
> mplayer song.mp3;
>
> and I run it like this:
>
> ./test.sh set set
> ./test.sh set clear
> ./test.sh clear set
> ./test.sh clear clear
>
> And nothing came out of the speaker, alas :(

Alas. I'll just remind one more time about `mixer ogain`.

Also check that pin sensing is working. Try to plug in/out headphones. 
With verbose messages enabled, you should see messages about that on 
console and in logs.

> What's strange is that the speaker actually works with OSS from ports,
> but when I use it (OSS) with mplayer it crashes the whole system
> whenever I try to skip in a video/audio file
>
> On Sun, Oct 28, 2012 at 9:58 PM, Big Yuuta <init.py at gmail.com> wrote:
>> On Sun, Oct 28, 2012 at 9:42 PM, Alexander Motin <mav at freebsd.org> wrote:
>>> On 28.10.2012 22:09, Big Yuuta wrote:
>>>>>
>>>>> CODEC configuration looks good and I see no problems in driver output. I
>>>>> think most likely problem is in CODEC wiring and power amplifier. Your
>>>>> CODEC
>>>>> has two GPIO lines and EAPD line. That gives 8 possible combinations. I
>>>>> would recommend you to try them all. GPIOs, as you tried could be set
>>>>> with
>>>>> hint.hdaa.0.gpio_config tunable. EAPD line can be controlled (0 or 100)
>>>>> by
>>>>> the ogain mixer control.
>>>>
>>>>
>>>> You mean combinations like:
>>>>
>>>> hint.hdaa.0.gpio_config="0=set 1=set 2=set"
>>>
>>>
>>> As I've told, there are only two GPIO pins, so only "0=X 1=Y", plus ogain
>>> mixer control.
>>
>> So that would be:
>>
>> hint.hdaa.0.gpio_config="0=set 1=set"
>> hint.hdaa.0.gpio_config="0=set 1=clear"
>> hint.hdaa.0.gpio_config="0=clear 1=set"
>> hint.hdaa.0.gpio_config="0=clear 1=clear"
>>
>> which I try with:
>>
>> mixer ogain 0:0
>> mixer ogain 100:100
>>
>> I'm going to check once again, but I think that unfortunately that didn't work.
>> I hope that I forgot a combination!
>>
>> Thanks again, Alexander


-- 
Alexander Motin