Variables on boot
Stevan Tiefert
stevan.tiefert at freenet.de
Wed Nov 30 11:37:01 GMT 2005
Albert Shih schrieb:
> Hello
>
> I try to install (with floppy) FreeBSD 5.4 on Proliant with Fiber Channel
> card.
>
> How can I pass some variable (normaly on loader.conf) in install ? I need
> to pass ispfw_load="YES" (that's what I put on my old serveur with same
> card in loader.conf).
>
> Regards.
>
>
> --
> Albert SHIH
> Universite de Paris 7 (Denis DIDEROT)
> U.F.R. de Mathematiques.
> 7 ième étage, plateau D, bureau 10
> Heure local/Local time:
> Wed Nov 30 12:25:27 CET 2005
> _______________________________________________
> freebsd-questions at freebsd.org mailing list
> http://lists.freebsd.org/mailman/listinfo/freebsd-questions
> To unsubscribe, send any mail to "freebsd-questions-unsubscribe at freebsd.org"
>
>
You put the boot.flp, kern1.flp, kern2.flp and then again the boot.flp.
After you put boot.flp you must see the beastie-loader-screen. And there
is a menu point (I think 6 Go to Loader prompt) you have to select.
There you can do a "set [anything]" and a finally "boot". Note that your
changes are only temporary for this one boot! You have to config
/boot/loader.conf finally again.
With regards
Stevan
--
Why my wife is happy when I do a "make buildkernel" and a "make
installkernel"? I have then a lot of time to do my housework :-(
More information about the freebsd-questions
mailing list