Linksys WPC11 v.4 problems in 5.2, 5.2.1 and 5.3-RC1

[Stephen P. Cravey]

I've just purchased a new 802.11b pcmcia card for a laptop and I'm
getting errors when I insert it. Is this card not supported yet, other
than debug sysctls, is there anythgin else I should check? Yes, i did
add pccard_enable to rc.conf.

I'm running 5.3-RC1 at the moment, but I have the same problem with
5.2-R and 5.2.1-R. Since I have no network interface, I'm stuck with
what I can install from CD.

I've included (what I think is) the pertinent debugging info:



Dmesg:
cbb0: <TI1121 PCI-CardBUS Bridge> at device 7.0 on pci0
cardbus0: <CardBus bus> on cbb0
pccard0: <16-bit PCCard Bus> on cbb0

Insert:
cardbus0: <network, ethernet> at device 0.0 (no driver attached)
cbb0: CardBus card activation failed

Debug Insert:
Status is 0x300000820
cbb0: card inserted: event=0x00000000, state=30000820
cbb0: cbb_power: 3V
TUPLE: LINKTARGET [3]: 43 49 53
Manufacturer ID: 00004c02
Functions: Network Adaptor, Multi-Functioned
Function Extension: 0102
Function Extension: 0280969800
Function Extension: 0200e1f505
Function Extension: 040600e04c390010
TUPLE: Unknown(0x1c) [2]: 02 ff
cardbus0: Opening BAR: type=IO, bar=10, len=0100
cardbus0: Opening BAR: type=MEM, bar=14, len=200
CIS reading done
cardbus0: Non-prefetchable memory at 88000000-880001ff
cardbus0: IO port at 1000-10ff
cardbus0: <network, ethernet> at device 0.0 (no driver attached)
cbb0: cbb_power: 0V
cbb0: CardBus card activation failed

Debug Remove:
Status is 0x30000026