RAID 1 in HP NetServer LC 2000

[Muhammad Reza]

Dear All,
Howto setup RAID 1 in HP NetServer LC 2000 ? I have 2 Seagate HDD that 
want to be mirror 1:1,
Can i do that from Symbios software or tool from my FreeBSD 4.10 ?

regards
reza
---snip---
sym0: <896> port 0x2000-0x20ff mem 
0xfd000000-0xfd001fff,0xfd002000-0xfd0023ff irq 11 at device 6.0 on pci3
sym0: Symbios NVRAM, ID 7, Fast-40, LVD, parity checking
sym0: open drain IRQ line driver, using on-chip SRAM
sym0: using LOAD/STORE-based firmware.
sym0: handling phase mismatch from SCRIPTS.
sym1: <896> port 0x2400-0x24ff mem 
0xfd004000-0xfd005fff,0xfd002400-0xfd0027ff irq 5 at device 6.1 on pci3
sym1: Symbios NVRAM, ID 7, Fast-40, LVD, parity checking
sym1: open drain IRQ line driver, using on-chip SRAM
sym1: using LOAD/STORE-based firmware.
sym1: handling phase mismatch from SCRIPTS.
---snap---
.
.
--snip--
da0 at sym1 bus 0 target 0 lun 0
da0: <SEAGATE ST318405LW 5063> Fixed Direct Access SCSI-3 device
da0: 80.000MB/s transfers (40.000MHz, offset 31, 16bit), Tagged Queueing 
Enabled
da0: 17501MB (35843670 512 byte sectors: 255H 63S/T 2231C)
da1 at sym1 bus 0 target 1 lun 0
da1: <SEAGATE ST318405LW 5063> Fixed Direct Access SCSI-3 device
da1: 80.000MB/s transfers (40.000MHz, offset 31, 16bit), Tagged Queueing 
Enabled
da1: 17501MB (35843670 512 byte sectors: 255H 63S/T 2231C)
---snap---