Western Digital WD360GD SATA disk on -CURRENT
Derek Ragona
derek at computinginnovations.com
Sat Nov 29 23:07:37 PST 2003
I have a server that uses the same chipset with a maxtor drive, no RAID
just a single drive. My hardware exact hardware is:
Adaptec SATA 1210SA (SiI 3112 SATA150 controller in non RAID mode with a
single drive) and a Maxtor 6Y120M0 120 GB drive
It is probed correctly with the ISO mini 5.2 beta, but it was still having
data problems with larger IO in multiuser. The error I get is:
ad4: timeout sending command=ca
ad4: error issuing DMA command
I will try the 11/29 snapshot and see if that is any better.
-Derek
At 10:56 PM 11/29/2003, Will Andrews wrote:
>Hi,
>
>Ever since I found the set of commits which broke probing this
>disk on/about September 1, I have attempted to boot a JPSNAP
>about once a week. Up to this day, on which I tried 5.2-BETA
>(official ISO), it has never again probed this drive correctly.
>
>I'm using it with a:
>
>atapci1 at pci2:6:0: class=0x018000 card=0x31121095 chip=0x31121095
>rev=0x02 hdr=0x00
> vendor = 'Silicon Image Inc (Was: CMD Technology Inc)'
> device = 'SiI 3112 SATARaid Controller'
> class = mass storage
>
>(note, no RAID has been configured, only one disk is attached)
>
>Has anyone had better luck? Thanks.
>
>Regards,
>--
>wca
>_______________________________________________
>freebsd-current at freebsd.org mailing list
>http://lists.freebsd.org/mailman/listinfo/freebsd-current
>To unsubscribe, send any mail to "freebsd-current-unsubscribe at freebsd.org"
More information about the freebsd-current
mailing list