Problems with Adaptec 29160.....

[Steffen Hansen]

Hi.... And btw. I'm new so bear with me....

 I'm trying to install a new Linux RH6.2/Oracle 
server with an Adaptec 29160 controller. So far
there's only two IBM18.5Gig drives attached to
the controller, but more will follow.

 The installation of RH6.2 causes no problems,
but when RH6.2 boots the std. SMP kernel, the
following messages appears when the Adaptec
driver loads :
----------------------------------------------------------------------------

(scsi0) <Adaptec AIC-7892 Ultra 160/m SCSI host adapter> found at PCI 0/16/0
(scsi0) Wide Channel, SCSI ID=7, 32/255 SCBs
(scsi0) Downloaded sequencer code... 392 instructions downloaded
scsi0 : Adaptec AHA274x/284x/294x (EISA/VLB/PCI-Fast SCSI) 5.2.1/5.2.0
	<Adaptec AIC-7892 Ultra 160/m SCSI host adapter>
scsi : 1 host
scsi : aborting command due to timeout : pid 0, scsi0, channel 0, id 0, lun
0 In
quiry 00 00 00 ff 00
(scsi0) BRKADRINT error (0xff):
  Illegal Host Access
  Illegal Sequencer address referenced
  Illegal Opcode in sequencer program
  Sequencer Ram Parity Error
  Data-Path Ram Parity Error
  Scratch Ram/SCB Array Ram Parity Error
  PCI Error detected
  CIOBUS Parity Error
(scsi0)   SEQADDR=0x1ff
Kernel panic: aic7xxx: unrecoverable BRKADRINT

In interrupt handler - not syncing

----------------------------------------------------------------------------

 This happens with the std. SMP kernel as well as with
Kernel 2.4.0-test1/2
  The driver version in the 2.2.14 kernel is 5.1.28 and 2.4.0
reports 5.2.1...

   It does NOT however die when using the linux-up kernel
that comes with RH6.2.....

 I hope that you're able to help me...

Kindest regards and tanx in advance..

Steffen Hansen
Den Blå Avis A/S, Denmark





To Unsubscribe: send mail to majordomo at FreeBSD.org
with "unsubscribe aic7xxx" in the body of the message