Via Epia CL10000 and VIA C3

[Dany Nativel]

My fileserver is running on a M6000 (pre-CL10000) using FreeBSD 5.2

I had some troubles compiling the kernel. The trick was to use :

- i686 in the kernel config
- i586 in the make file   (full 686 compilation cannot be used due to a 
missing instruction)

But in your case I think you processor supports 686 for the compilation.

You shouldn't have a problem with 4.9 due to the older gcc (less 
options) as far as compilation goes. Now you should check if the network 
interface is supported.

I forgot, are you planning to run X on it ?  I didn't hear a lot of good 
thing regarding XFree86 support on the CLE266.

Hope this will help.
Dany

Christophe Prevotaux wrote:

>Hello,
>
>I would like to know if FreeBSD 4-STABLE (or 4.9 Release) supports
>the Via Epia CL10000 Motherboard and CPU VIA C3 1Ghz ? 
>
>_______________________________________________
>freebsd-stable at freebsd.org mailing list
>http://lists.freebsd.org/mailman/listinfo/freebsd-stable
>To unsubscribe, send any mail to "freebsd-stable-unsubscribe at freebsd.org"
>  
>