AHA-1542CP and FreeBSD 5.3

[Rick Voland]

Has anyone succeeded at getting FreeBSD 5.3 to recognize an Adaptec 
AHA-1542CP?  This is a PNP-ISA device.  It worked fine under FreeBSD 
4.10 SMP and Redhat Linux 9 SMP.  I also have a DPT PM-2044UW (PCI) 
installed in the same system that works fine.  FreeBSD 5.3 boots fine 
and is stable, but does not recognize the AHA-1542CP.

I tried
hint.aha.0.at="isa"

and later added

hint.aha.0.irq=11
hint.aha.0.port="0x334"

I get messages like:

ADP1542: adding irq mask 0xdc00
ADP1542: adding dma mask 0xe0
ADP1542: start dependent (0)
ADP1542: adding io range 0x330-0x333, size=0x4, align=0x4
ADP1542: start dependent (1)
ADP1542: adding io range 0x334-0x337, size=0x4, align=0x4
ADP1542: start dependent (1)
ADP1542: adding io range 0x234-0x237, size=0x4, align=0x4
ADP1542: start dependent (1)
ADP1542: adding io range 0x230-0x233, size=0x4, align=0x4
ADP1542: start dependent (1)
ADP1542: adding io range 0x134-0x137, size=0x4, align=0x4
ADP1542: start dependent (2)
ADP1542: adding io range 0x130-0x133, size=0x4, align=0x4
ADP1542: end dependent
ADP1542: adding memory range 0xc8000-0xdffff, size=0x4000, align=0x4000
ex_isa_identify()
unknown: status reg test failed ff
unknown: status reg test failed ff
unknown: status reg test failed ff
unknown: status reg test failed ff
unknown: status reg test failed ff
pnpbios: 13 devices, largest 126 bytes

[snip]

aha0 failed to probe on isa0

-----------------------

Thanks for any suggestions.




-- 

rpvoland at spamcop.net