APC BioPod

[Mike Ginsburg]

Hello,
I am looking into using fingerprint authentication on my machine and I 
have an APC BioPod scanner (usb) to work with. When I plug the scanner 
into the usb port, dmesg shows the following

ugen1: vendor 0x08ff Fingerprint Sensor, rev 1.10/0.00, addr 4

Vendor 0x08ff points to AUTHENTEC

The following directories are created
/dev/ugen1
/dev/ugen1.1
/dev/ugen1.2

Does anyone know of software that can be used to work with this 
fingerprint scanner on freeBSD (6.1)? Or even if it is possible to just 
read the raw data from the stream? Thanks in advance.

MikeG

Mike Ginsburg
Collaborative Fusion, Inc.
mginsburg at collaborativefusion.com
412-422-3463 x4015

-- 
****************************************************************
IMPORTANT: This message contains confidential information
and is intended only for the individual named. If the reader of
this message is not an intended recipient (or the individual
responsible for the delivery of this message to an intended
recipient), please be advised that any re-use, dissemination,
distribution or copying of this message is prohibited. Please
notify the sender immediately by e-mail if you have received
this e-mail by mistake and delete this e-mail from your system.
E-mail transmission cannot be guaranteed to be secure or
error-free as information could be intercepted, corrupted, lost,
destroyed, arrive late or incomplete, or contain viruses. The
sender therefore does not accept liability for any errors or
omissions in the contents of this message, which arise as a
result of e-mail transmission.
****************************************************************