Dlink DWL-G520+

[Luís Cargnini]

i forget i use pf firewall i trie with it and worked a little bit i
must mantain the firewall or remove it.
On 05/01/06, Luís Cargnini <lvcargnini at gmail.com> wrote:
> ok did this all but link seems unstable and i dont get much speed
> above 7~12k betwen ap and pc, how could i improve this one. Second
> system seems to have "weeping" "ic ic ic " my mouse and my system make
> some pauses, my processor achieve at least 17% of processing in idle
> mode, how to fix this things ?
> and my link crash sometimes.
>
> On 01/01/06, Roman Dewald <romad at gmx.de> wrote:
> >
> > > Hi i have an Dlink DWL-G520+ as following:
> > > ndis0 at pci0:9:0: class=0x028000 card=0x3b041186 chip=0x9066104c rev=0x00 hdr=0x00
> > >     vendor   = 'Texas Instruments (TI)'
> > >     device   = 'TNETW1130(ACX111) 802.11b/g Wireless Cardbus/PCI Adapter'
> > >     class    = network
> > > but it isn't working well, someone knows if exist an native driver or
> > > how i must proceed (walktrhough) to put this net device to work
> > I have had problems with this card and ndis driver under 5.4 Release. I
> > upgraded my system to the 6.0 Release and it worked fine.
> >
> > To get the driver working, you have first to bild a module for the
> > FreeBSD kernel from Windows drivers supplied with your card.
> > I used ndisgen to convert the driver. You will get some files after the
> > conversion you will a couple of files.
> > Then you can load the converted module with kldload +absolute path to
> > the converted module. You can check dmesg to ensure the module was
> > loaded successfully. You will see something like that:
> >
> > ndis0: <D-Link AirPlus G+ DWL-G520+ Wireless PCI Adapter> mem
> > 0xcfffa000-0xcfffbfff,0xcffc0000-0xcffdffff irq 19 at device 11.0 on
> > pci0
> >
> > Afterwards you have to load the wlan_wep module to get the wep
> > encryption working.
> > Now you can configure the network settings with ifconfig.
> >
> > Roman
> >
> >
> > > Thanks && Regards
> > > Msc. Bsc. Luís Vitório Cargnini
> > > IEEE Member
> > > Mastering Degree student @ PUC-RS Electrical Engineer Faculty
> > > _______________________________________________
> > > freebsd-hardware at freebsd.org mailing list
> > > http://lists.freebsd.org/mailman/listinfo/freebsd-hardware
> > > To unsubscribe, send any mail to "freebsd-hardware-unsubscribe at freebsd.org"
> > >
> >
> >
>
>
> --
> Thanks && Regards
> Msc. Bsc. Luís Vitório Cargnini
> IEEE Member
> Mastering Degree student @ PUC-RS Electrical Engineer Faculty
>


--
Thanks && Regards
Msc. Bsc. Luís Vitório Cargnini
IEEE Member
Mastering Degree student @ PUC-RS Electrical Engineer Faculty