Hardware supported by ng_frame_relay?
Roman Kurakin
rik at inse.ru
Thu Jan 19 06:48:19 UTC 2012
Jan Mikkelsen wrote:
> On 15/01/2012, at 6:00 PM, Roman Kurakin wrote:
>
>
>> Hi,
>>
>> Jan Mikkelsen wrote:
>>
>>> Hi,
>>>
>>> I'm looking to upgrade a system running frame relay over a Sangoma A101 card and WANPIPE.
>>>
>>> Sangoma do not support FreeBSD anymore, so I'm looking for alternatives.
>>>
>>> What hardware does ng_frame_relay support now that ar(4) and sr(4) are not in FreeBSD 9?
>>>
>>> Specifically, will ng_frame_relay work with a Digium TE121 and ports/dahdi-kmod?
>>>
>>> Any suggestions welcome, G.703, X.21 or V.35 interfaces OK.
>>>
>>>
>> Check also www. cronyx. ru for ce(4) and cp(4). As far as I know, an old digium adapters were using
>> software framer for HDLC, but I don'k know the current state. If they didn't provide hardware framer
>> now, I suggest to check for any other adapter.
>>
>
>
> Thanks. Just had a look at their site; they support up to 6.x, there is a red note saying 7.x is not supported. I suspect that would also apply to 8.x and 9.x ...
>
I know, I quit the company and support was stopped at that point. But
code in the base tree,
and should work.
> For now going with a standalone router. Might have a look at the Digium card more closely if I have a different application for it ...
>
Then take a look at www. nsg. ru they have nice linux based boxes.
Though, I didn't play with them by my self.
Best regards,
rik
rik
> Regards,
>
> Jan.
>
>
> _______________________________________________
> freebsd-hackers at freebsd.org mailing list
> http://lists.freebsd.org/mailman/listinfo/freebsd-hackers
> To unsubscribe, send any mail to "freebsd-hackers-unsubscribe at freebsd.org"
>
More information about the freebsd-hackers
mailing list