29160, dat24e and kernel 2.4.7 problem

[kf]

On Wed, 19 Dec 2001, Danilo Godec wrote:

= On Mon, 17 Dec 2001, sbarthfr wrote:
=
= > I would like to use a 29160 SCSI card to drive my HP DAT24 (external)
= > with a RedHat 7.2. There is a problem when I try to use the /dev/st0
= > device:
= >
= > (1) there's a "attached devices: none" in the /proc/scsi/scsi file
= >
= > (2) when I try a "mt -f /dev/st0 stat" I've got the
= > message "/dev/st0: No such device"
= >
= > (3) the "dmesg" on my system is
= >
= > SCSI subsystem driver Revision: 1.00
= > PCI: Found IRQ 9 for device 00:12.0
= > PCI: Sharing IRQ 9 with 00:09.0
= > (scsi0) <Adaptec AIC-7892 Ultra 160/m SCSI host adapter> found at PCI
= > 0/18/0
= > (scsi0) Wide Channel, SCSI ID=7, 32/255 SCBs
= > (scsi0) Downloading sequencer code... 396 instructions downloaded
= > scsi0 : Adaptec AHA274x/284x/294x (EISA/VLB/PCI-Fast SCSI) 5.2.4/5.2.0
= >        <Adaptec AIC-7892 Ultra 160/m SCSI host adapter>
= >   Vendor: HP        Model: C1537A            Rev: L105
= >   Type:   Sequential-Access                  ANSI SCSI revision: 02
= > scsi : 0 hosts left.
= >
= > What's the problem ? Can someone help me ?
=
= If you use modules, do you have st.o module loaded? If you don't use
= modules, you should have st (SCSI tape) support compiled in the kernel.
=
= Then you should see device /dev/st0 and /dev/nst0.
=
=    D.
=

Also, run the command "cdrecord -scanbus" to see if the device hanging off
the SCSI card is being detected.

hth,
kf

-- 
		 Cleveland Linux Users Group
		  http://cleveland.lug.net/


To Unsubscribe: send mail to majordomo at FreeBSD.org
with "unsubscribe aic7xxx" in the body of the message