svn commit: r232914 - head/sys/mips/atheros
Adrian Chadd
adrian at FreeBSD.org
Tue Mar 13 06:28:53 UTC 2012
Author: adrian
Date: Tue Mar 13 06:28:52 2012
New Revision: 232914
URL: http://svn.freebsd.org/changeset/base/232914
Log:
Fix link status handling on if_arge upon system boot to allow bootp/NFS to
function.
From the submitter:
This patch fixes an issue I encountered using an NFS root with an
ar71xx-based MikroTik RouterBoard 450G on -current where the kernel fails
to contact a DHCP/BOOTP server via if_arge when it otherwise should be able
to. This may be the same issue that Monthadar Al Jaberi reported against
an RSPRO on 6 March, as the signature is the same:
%%%
DHCP/BOOTP timeout for server 255.255.255.255
DHCP/BOOTP timeout for server 255.255.255.255
DHCP/BOOTP timeout for server 255.255.255.255
.
.
.
DHCP/BOOTP timeout for server 255.255.255.255
DHCP/BOOTP timeout for server 255.255.255.255
arge0: initialization failed: no memory for rx buffers
DHCP/BOOTP timeout for server 255.255.255.255
arge0: initialization failed: no memory for rx buffers
%%%
The primary issue that I found is that the DHCP/BOOTP message that
bootpc_call() is sending never makes it onto the wire, which I believe is
due to the following:
- Last December, a change was made to the ifioctl that bootpc_call() uses
to adjust the netmask around the sosend().
- The new ioctl (SIOCAIFADDR) performs an if_init when invoked, whereas the
old one (SIOCSIFNETMASK) did not.
- if_arge maintains its own sense of link state in sc->arge_link_status.
- On a single-phy interface, sc->arge_link_status is initialized to 0 in
arge_init_locked().
- sc->arge_link_status remains 0 until a phy state change notification
causes arge_link_task to run, notice the link is up, and set it to 1.
- The inits caused by the ifioctls in bootpc_call are reinitializing the
interface, but not the phy, so sc->arge_link_status goes to 0 and remains
there.
- arge_start_locked() always sees sc->arge_link_status == 0 and returns
without queuing anything.
The attached patch changes arge_init_locked() such that in the single-phy
case, instead of initializing sc->arge_link_status to 0, it runs
arge_link_task() to set it according to the current phy state. This change
has allowed my setup to mount an NFS root successfully.
Submitted by: Patrick Kelsey <kelsey at ieee.org>
Reviewed by: juli
Modified:
head/sys/mips/atheros/if_arge.c
Modified: head/sys/mips/atheros/if_arge.c
==============================================================================
--- head/sys/mips/atheros/if_arge.c Tue Mar 13 06:22:49 2012 (r232913)
+++ head/sys/mips/atheros/if_arge.c Tue Mar 13 06:28:52 2012 (r232914)
@@ -110,6 +110,7 @@ static int arge_ioctl(struct ifnet *, u_
static void arge_init(void *);
static void arge_init_locked(struct arge_softc *);
static void arge_link_task(void *, int);
+static void arge_update_link_locked(struct arge_softc *sc);
static void arge_set_pll(struct arge_softc *, int, int);
static int arge_miibus_readreg(device_t, int, int);
static void arge_miibus_statchg(device_t);
@@ -684,13 +685,20 @@ static void
arge_link_task(void *arg, int pending)
{
struct arge_softc *sc;
+ sc = (struct arge_softc *)arg;
+
+ ARGE_LOCK(sc);
+ arge_update_link_locked(sc);
+ ARGE_UNLOCK(sc);
+}
+
+static void
+arge_update_link_locked(struct arge_softc *sc)
+{
struct mii_data *mii;
struct ifnet *ifp;
uint32_t media, duplex;
- sc = (struct arge_softc *)arg;
-
- ARGE_LOCK(sc);
mii = device_get_softc(sc->arge_miibus);
ifp = sc->arge_ifp;
if (mii == NULL || ifp == NULL ||
@@ -708,10 +716,10 @@ arge_link_task(void *arg, int pending)
duplex = mii->mii_media_active & IFM_GMASK;
arge_set_pll(sc, media, duplex);
}
- } else
+ } else {
sc->arge_link_status = 0;
+ }
- ARGE_UNLOCK(sc);
}
static void
@@ -853,7 +861,6 @@ arge_init_locked(struct arge_softc *sc)
if (sc->arge_miibus) {
- sc->arge_link_status = 0;
mii = device_get_softc(sc->arge_miibus);
mii_mediachg(mii);
}
@@ -867,8 +874,10 @@ arge_init_locked(struct arge_softc *sc)
ifp->if_drv_flags |= IFF_DRV_RUNNING;
ifp->if_drv_flags &= ~IFF_DRV_OACTIVE;
- if (sc->arge_miibus)
+ if (sc->arge_miibus) {
callout_reset(&sc->arge_stat_callout, hz, arge_tick, sc);
+ arge_update_link_locked(sc);
+ }
ARGE_WRITE(sc, AR71XX_DMA_TX_DESC, ARGE_TX_RING_ADDR(sc, 0));
ARGE_WRITE(sc, AR71XX_DMA_RX_DESC, ARGE_RX_RING_ADDR(sc, 0));
More information about the svn-src-head
mailing list