svn commit: r328257 - in head/sys: arm/broadcom/bcm2835 dts/arm modules
Emmanuel Vadot
manu at bidouilliste.com
Tue Jan 30 09:58:22 UTC 2018
On Tue, 30 Jan 2018 09:47:57 +0000
"Poul-Henning Kamp" <phk at phk.freebsd.dk> wrote:
> --------
> In message <20180130094251.GA85100 at bluezbox.com>, Oleksandr Tymoshenko writes:
> >Poul-Henning Kamp (phk at phk.freebsd.dk) wrote:
>
> >> But only if you add pwm.dtbo to config.txt and reboot, because
> >> I see nothing indicating that we will put it there in the
> >> release images we (may start to) produce ?
> >
> >No. We're going to add them in our release image. That's what
> >I meant by "working with Glen and Brad".
>
> Ok, that was a bit more understated than I could decode.
>
> (My understanding until now was that you would have to do
> that by hand if you wanted to use PWM.)
>
> If the pwm overlay is going to be loaded by default, then I
> have no objection to removing the ignore-disable hack.
I don't think that we want to load it by default as it would mean that
some GPIO are now unusable as they are pwm pins now.
If I understood gonzo correctly we will install it by default and if
someone want to use pwm he just need to add it
in /boot/msdos/config.txt to the list of overlays loaded by the rpi
firmware.
> --
> Poul-Henning Kamp | UNIX since Zilog Zeus 3.20
> phk at FreeBSD.ORG | TCP/IP since RFC 956
> FreeBSD committer | BSD since 4.3-tahoe
> Never attribute to malice what can adequately be explained by incompetence.
--
Emmanuel Vadot <manu at bidouilliste.com> <manu at freebsd.org>
More information about the svn-src-all
mailing list