Xorg -configure ... Segmentation fault at address 0x0
Warren Block
wblock at wonkity.com
Wed Dec 17 02:32:12 UTC 2014
On Tue, 16 Dec 2014, Kevin Oberman wrote:
> On Mon, Dec 15, 2014 at 6:02 PM, Ronald F. Guilmette <rfg at tristatelogic.com>
> wrote:
>
>>
>>
>> I'm trying to bring up a new wokrstation. I've just successfully
>> installed 10.1-RELEASE and I'm now just trying to get X properly
>> configured. So far it isn't going at all well.
>>
>> Logs are attached below. The system, in question contains AMD A4-6300
>> APU. I found this page which says, at the very bottom, that this is a
>> known problem:
>>
>> https://wiki.freebsd.org/Graphics
>>
>> Is there an ETA for a fix?
>>
>> Not that I have heard, but i may have missed something.
>
> To ask a really dumb question, why are you doing "Xorg -configure"? One
> reason that there has been a lot of breakage in Xorg -configure is that it
> is so little used and less often needed.
Unfortunately, the Handbook still recommends it. I added a Quick Start
section that shows using it without generating a config file, but now I
see the HTML version being served by FreeBSD.org is from September.
Really, the whole Xorg chapter needs a rewrite. I have loose outlines
for that, but it's a big job and there have been numerous other things
that have popped up recently.
More information about the freebsd-x11
mailing list