ath0 performence issues "ar9300_Stub_GetCTSTimeout" "ar9300_Stub_GetCTSTimeout
Miguel Clara
miguelmclara at gmail.com
Sun Mar 22 04:11:34 UTC 2015
On Sun, Mar 22, 2015 at 3:58 AM, Adrian Chadd <adrian at freebsd.org> wrote:
> Ok, hm. There's a lot of short retry errors / CRC errors during what
> I'm guessing is the speed test, which is odd if it's on 5GHz.
>
>
> It did change when I got back to the laptop, but it on 5g since then... I
need to see if I figure out why wpa_supplicant does that... or maybe just
remove the 2.4g for the list, its usefull if I need to take the laptop to
the bedroom, cause 5g won't reach there... while 2.4 does, but those are
really rare occasions...
I'm 99% sure it wasn't connected to the 2.4g when I run the results, but I
admit at the time I didn't look into ifconfig... since I had it cahnge to
5G just before...
In any case this is from now just to be sure:
wlan0: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> metric 0 mtu 1500
ether *:5b
inet 1.1.1.1 netmask 0xffffff00 broadcast 10.10.50.255
nd6 options=29<PERFORMNUD,IFDISABLED,AUTO_LINKLOCAL>
media: IEEE 802.11 Wireless Ethernet MCS mode 11na
status: associated
ssid ssid5G channel 48 (5240 MHz 11a ht/40-) bssid 60:*
regdomain 108 indoor ecm authmode WPA2/802.11i privacy ON
deftxkey UNDEF AES-CCM 2:128-bit AES-CCM 3:128-bit txpower 30 bmiss
7
mcastrate 6 mgmtrate 6 scanvalid 60 ampdulimit 64k ampdudensity 4
shortgi wme burst roaming MANUAL
groups: wlan
% speedtest
Retrieving speedtest.net configuration...
Retrieving speedtest.net server list...
Testing from Vodafone Portugal (89.114.40.155)...
Selecting best server based on latency...
Hosted by Vodafone PT (Porto) [16.63 km]: 5.68 ms
Testing download speed........................................
Download: 33.00 Mbits/s
Testing upload speed..................................................
Upload: 6.91 Mbits/s
athstats 1 -> http://pastebin.com/raw.php?i=1JgV3Ctd
cat /var/run/dmesg.boot |grep ath
ath0: <Atheros AR946x/AR948x> mem 0xc0400000-0xc047ffff irq 19 at device
0.0 on pci2
ath0: [HT] enabling HT modes
ath0: [HT] enabling short-GI in 20MHz mode
ath0: [HT] 1 stream STBC receive enabled
ath0: [HT] 1 stream STBC transmit enabled
ath0: [HT] 2 RX streams; 2 TX streams
ath0: AR9460 mac 640.2 RF5110 phy 3118.4
ath0: 2GHz radio: 0x0000; 5GHz radio: 0x0000
More information about the freebsd-wireless
mailing list