D-Link DWA-131 A1 (Realtek RTL8191SU) not working
Idwer Vollering
vidwer at gmail.com
Tue Nov 18 14:33:03 UTC 2014
2014-11-18 11:04 GMT+01:00 Ben Woods <woodsb02 at gmail.com>:
> Hmm... turns out this is an issue with authentication with wpa_supplicant.
> If I turn off security I can connect just fine.
Well, disabling AP security features is not the right solution.
I have the EDUP adapter that uses if_rsu, and when I crank the debug
level all the way up it works most of the time/
Can you apply the following patch to 10-STABLE or -CURRENT
(committers, are you reading this? :) ), rebuild kernel and before
rebooting add "hw.usb.rsu.debug=5" to /boot/loader.conf ?
Index: sys/dev/usb/wlan/if_rsu.c
===================================================================
--- sys/dev/usb/wlan/if_rsu.c (revision 274656)
+++ sys/dev/usb/wlan/if_rsu.c (working copy)
@@ -48,6 +48,7 @@
#include <net/if_dl.h>
#include <net/if_media.h>
#include <net/if_types.h>
+#include <net/if_var.h>
#include <netinet/in.h>
#include <netinet/in_systm.h>
@@ -68,11 +69,13 @@
#include <dev/usb/wlan/if_rsureg.h>
+static SYSCTL_NODE(_hw_usb, OID_AUTO, rsu, CTLFLAG_RW, 0, "USB rsu");
+
#ifdef USB_DEBUG
-static int rsu_debug = 0;
-SYSCTL_NODE(_hw_usb, OID_AUTO, rsu, CTLFLAG_RW, 0, "USB rsu");
-SYSCTL_INT(_hw_usb_rsu, OID_AUTO, debug, CTLFLAG_RW, &rsu_debug, 0,
+int rsu_debug = 0;
+SYSCTL_INT(_hw_usb_rsu, OID_AUTO, debug, CTLFLAG_RW | CTLFLAG_TUN,
&rsu_debug, 0,
"Debug level");
+TUNABLE_INT("hw.usb.rsu.debug", &rsu_debug);
#endif
static const STRUCT_USB_HOST_ID rsu_devs[] = {
@@ -1277,7 +1280,7 @@
DPRINTF("WPS PBC pushed.\n");
break;
case R92S_EVT_FWDBG:
- if (ifp->if_flags & IFF_DEBUG) {
+ if (rsu_debug >= 6) {
buf[60] = '\0';
printf("FWDBG: %s\n", (char *)buf);
}
Index: sys/modules/usb/rsu/Makefile
===================================================================
--- sys/modules/usb/rsu/Makefile (revision 274656)
+++ sys/modules/usb/rsu/Makefile (working copy)
@@ -6,5 +6,6 @@
SRCS = if_rsu.c if_rsureg.h \
bus_if.h device_if.h \
opt_bus.h opt_usb.h usb_if.h usbdevs.h
+CFLAGS+= -DUSB_DEBUG
.include <bsd.kmod.mk>
>
> Other devices devices on my network are connecting fine with WPA2 AES PSK.
> My wifi router is a TP-Link Archer D9 operating with both 2.4GHz and 5GHz.
> I will go and try on another wifi network and report back if that works.
>
> % sudo cat /etc/wpa_supplicant.conf
> ctrl_interface=/var/run/wpa_supplicant
> eapol_version=2
> ap_scan=1
> fast_reauth=1
> network={
> ssid="MYSSIDHERE"
> key_mgmt="WPA-PSK"
> psk="MYPSKHERE"
> }
>
> For the record, details of my wireless adapter:
> % sudo usbconfig -d ugen2.3 dump_device_desc
> ugen2.3: <product 0x3303 vendor 0x07d1> at usbus2, cfg=0 md=HOST spd=HIGH
> (480Mbps) pwr=ON (500mA)
> bLength = 0x0012
> bDescriptorType = 0x0001
> bcdUSB = 0x0200
> bDeviceClass = 0x0000
> bDeviceSubClass = 0x0000
> bDeviceProtocol = 0x0000
> bMaxPacketSize0 = 0x0040
> idVendor = 0x07d1
> idProduct = 0x3303
> bcdDevice = 0x0200
> iManufacturer = 0x0001 <Manufacturer Realtek >
> iProduct = 0x0002 <11n Adapter>
> iSerialNumber = 0x0003 <00e04c000001>
> bNumConfigurations = 0x0001
>
> Any thoughts?
>
> Regards,
> Ben
>
>
> --
> From: Benjamin Woods
> woodsb02 at gmail.com
>
> On 18 November 2014 16:32, Ben Woods <woodsb02 at gmail.com> wrote:
>
>> No worries :)
>>
>> Got any advice on how to diagnose why it's able to scan and lock onto the
>> ssid (shows it in ifconfig), but not able to get an IP address with DHCP
>> or communicate with a manual IP address?
>>
>> On Tuesday, November 18, 2014, Kevin Lo <kevlo at freebsd.org> wrote:
>>
>>> Argh! I think I need more coffee. rsu(4) does support this chipset.
>>> Sorry for the noise.
>>>
>>> Kevin
>>>
>>> On Tue, Nov 18, 2014 at 03:08:37PM +0800, Kevin Lo wrote:
>>> > I'm pretty sure. See OpenBSD cvs log:
>>> > http://marc.info/?l=openbsd-cvs&m=128897633210060&w=2
>>> >
>>> > I'll be fixing rsu(4), thanks.
>>> >
>>> > Kevin
>>> >
>>> > On Tue, Nov 18, 2014 at 02:41:18PM +0800, Ben Woods wrote:
>>> > >
>>> > > Actually, the rsu(4) man page mentions the RTL8191SU chipset:
>>> > > https://www.freebsd.org/cgi/man.cgi?query=rsu&sektion=4
>>> > >
>>> > > And it appears to be in the code:
>>> > >
>>> http://svnweb.freebsd.org/base/head/sys/dev/usb/wlan/if_rsu.c?view=markup
>>> > >
>>> > > Are you sure it is not supported?
>>> > >
>>> > > Regards,
>>> > > Ben
>>> > >
>>> > >
>>> > > --
>>> > > From: Benjamin Woods
>>> > > woodsb02 at gmail.com
>>> > >
>>> > > On 18 November 2014 14:21, Ben Woods <woodsb02 at gmail.com> wrote:
>>> > >
>>> > > > There seems to be some misalignment with the official release
>>> notes, which
>>> > > > specifically mention the D-Link DWA-131 A1 is supported:
>>> > > > https://www.freebsd.org/releases/10.1R/hardware.html
>>> > > >
>>> > > > However, according to this page it is the RTL8191SU chipset:
>>> > > > https://wikidevi.com/wiki/D-Link_DWA-131_rev_A1
>>> > > >
>>> > > > Apparently the RTL8191SU chipset is supported by the OpenBSD rsu(4)
>>> driver:
>>> > > > http://www.undeadly.org/cgi?action=article&sid=20101216231634
>>> > > >
>>> > > > Regards,
>>> > > > Ben
>>> > > >
>>> > > >
>>> > > >
>>> > > >
>>> > > > --
>>> > > > From: Benjamin Woods
>>> > > > woodsb02 at gmail.com
>>> > > >
>>> > > > On 18 November 2014 13:56, Kevin Lo <kevlo at freebsd.org> wrote:
>>> > > >
>>> > > >> The RTL8191SU chipset is not supported.
>>> > > >>
>>> > > >> Kevin
>>> > > >> On Tue, Nov 18, 2014 at 01:29:57PM +0800, Ben Woods wrote:
>>> > > >> >
>>> > > >> > I should mention I am running FreeBSD 10.1-RELEASE
>>> > > >> >
>>> > > >> >
>>> > > >> > --
>>> > > >> > From: Benjamin Woods
>>> > > >> > woodsb02 at gmail.com
>>> > > >> >
>>> > > >> > On 18 November 2014 13:23, Ben Woods <woodsb02 at gmail.com> wrote:
>>> > > >> >
>>> > > >> > > Hey guys,
>>> > > >> > >
>>> > > >> > > I am trying to get my D-Link DWA-131 A1 working, with some
>>> success
>>> > > >> but no
>>> > > >> > > network connectivity.
>>> > > >> > >
>>> > > >> > > It shows up in my usb list with device id 07d1:3303. The
>>> driver pages
>>> > > >> > > suggest this should be working with the rsu(4) driver and
>>> potentially
>>> > > >> > > the rsu-rtl8712fw firmware, according to these:
>>> > > >> > > https://www.freebsd.org/cgi/man.cgi?query=rsu&sektion=4
>>> > > >> > > http://www.undeadly.org/cgi?action=article&sid=20101216231634
>>> > > >> > > https://wikidevi.com/wiki/D-Link_DWA-131_rev_A1
>>> > > >> > >
>>> > > >> > > I have added the following to /boot/loader.conf and rebooted:
>>> > > >> > > legal.realtek.license_ack=1
>>> > > >> > > rsu-rtl8712fw_load="YES"
>>> > > >> > >
>>> > > >> > > It shows up in ifconfig, and even scans and finds wireless
>>> access
>>> > > >> points.
>>> > > >> > > I have my WPA ssid and psk details for my access point stored
>>> in
>>> > > >> > > /etc/wpa_supplicant.conf. I can see from ifconfig that it is
>>> trying to
>>> > > >> > > associate with the correct access point ssid and do DHCP, but
>>> it never
>>> > > >> > > obtains an IP address.
>>> > > >> > >
>>> > > >> > > Has anyone had this issue before? Anyone know how can I go
>>> about
>>> > > >> > > troubleshooting this further?
>>> > > >> > >
>>> > > >> > > Regards,
>>> > > >> > > Ben
>>> > > >> > >
>>> > > >> > > --
>>> > > >> > > From: Benjamin Woods
>>> > > >> > > woodsb02 at gmail.com
>>> > > >> > >
>>> > > >> > _______________________________________________
>>> > > >> > freebsd-wireless at freebsd.org mailing list
>>> > > >> > http://lists.freebsd.org/mailman/listinfo/freebsd-wireless
>>> > > >> > To unsubscribe, send any mail to "
>>> > > >> freebsd-wireless-unsubscribe at freebsd.org"
>>> > > >> >
>>> > > >>
>>> > > >
>>> > > >
>>> > > _______________________________________________
>>> > > freebsd-wireless at freebsd.org mailing list
>>> > > http://lists.freebsd.org/mailman/listinfo/freebsd-wireless
>>> > > To unsubscribe, send any mail to "
>>> freebsd-wireless-unsubscribe at freebsd.org"
>>> > >
>>> > _______________________________________________
>>> > freebsd-wireless at freebsd.org mailing list
>>> > http://lists.freebsd.org/mailman/listinfo/freebsd-wireless
>>> > To unsubscribe, send any mail to "
>>> freebsd-wireless-unsubscribe at freebsd.org"
>>>
>>
>>
>> --
>>
>> --
>> From: Benjamin Woods
>> woodsb02 at gmail.com
>>
> _______________________________________________
> freebsd-wireless at freebsd.org mailing list
> http://lists.freebsd.org/mailman/listinfo/freebsd-wireless
> To unsubscribe, send any mail to "freebsd-wireless-unsubscribe at freebsd.org"
More information about the freebsd-wireless
mailing list