Broadcom BCM4312 802.11b/g in 11-CURRENT

[Matthias Apitz]

Hello,

I have a 11-CURRENT from August 8, and ports from the day after:

FreeBSD tiny-r269739 11.0-CURRENT FreeBSD 11.0-CURRENT #1 r269739M: Fri Aug 15 18:07:41 CEST 2014     guru at vm-tiny-r269739:/usr/obj/usr/src/sys/GENERIC  i386

The configuration used for the Wifi card is:

rc.conf:

wlans_bwn0="wlan0"
ifconfig_wlan0="WPA DHCP"

loader.conf

if_bwn_load="YES"
bwn_v4_lp_ucode_load="YES"

The Wifi comes up fine on boot with WPA and DHCP assigns IP addr and
routing:

wlan0: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> metric 0 mtu 1500
	ether 90:4c:e5:00:06:ce
	inet 192.168.2.100 netmask 0xffffff00 broadcast 192.168.2.255 
	nd6 options=29<PERFORMNUD,IFDISABLED,AUTO_LINKLOCAL>
	media: IEEE 802.11 Wireless Ethernet OFDM/54Mbps mode 11g
	status: associated
	ssid tarara channel 7 (2442 MHz 11g) bssid 00:13:f7:0d:08:48
	country US authmode WPA2/802.11i privacy ON deftxkey UNDEF
	AES-CCM 4:128-bit txpower 30 bmiss 7 scanvalid 60 bgscan
	bgscanintvl 300 bgscanidle 250 roam:rssi 7 roam:rate 5 protmode CTS
	wme roaming MANUAL

I even can do a DNS lookup and transfer some ~10 PING to Internet, but
after this it gets stuck. Below is a 'dmesg | fgrep -i bwn'. Let me know
if someone needs a complete dmesg output.

What else can I do to help debugging? Is this card supported at all in
11-CURRENT?

Thanks

	matthias

Preloaded elf module "/boot/kernel/if_bwn.ko" at 0xc18478e8.
Preloaded elf module "/boot/kernel/siba_bwn.ko" at 0xc1847cbc.
Preloaded elf module "/boot/modules/bwn_v4_lp_ucode.ko" at 0xc184806c.
firmware: 'bwn_v4_lp_ucode' version 0: 0 bytes loaded at 0xc181b084
firmware: 'bwn_v4_lp_ucode5' version 0: 22264 bytes loaded at 0xc181b084
firmware: 'bwn_v4_lp_ucode11' version 0: 32776 bytes loaded at 0xc182077c
firmware: 'bwn_v4_lp_ucode13' version 0: 31440 bytes loaded at 0xc1828784
firmware: 'bwn_v4_lp_ucode14' version 0: 31000 bytes loaded at 0xc1830254
firmware: 'bwn_v4_lp_ucode15' version 0: 34672 bytes loaded at 0xc1837b6c
firmware: 'bwn_v4_lp_pcm5' version 0: 1320 bytes loaded at 0xc18402dc
firmware: 'bwn_v4_lp_a0g1initvals5' version 0: 1848 bytes loaded at 0xc1840804
firmware: 'bwn_v4_lp_a0g0initvals5' version 0: 1848 bytes loaded at 0xc1840f3c
firmware: 'bwn_v4_lp_b0g0initvals5' version 0: 1848 bytes loaded at 0xc1841674
firmware: 'bwn_v4_lp_b0g0initvals13' version 0: 2126 bytes loaded at 0xc1841dac
firmware: 'bwn_v4_lp_a0g1bsinitvals5' version 0: 178 bytes loaded at 0xc18425fa
firmware: 'bwn_v4_lp_a0g0bsinitvals5' version 0: 178 bytes loaded at 0xc18426ac
firmware: 'bwn_v4_lp_b0g0bsinitvals5' version 0: 178 bytes loaded at 0xc184275e
firmware: 'bwn_v4_lp_lp0initvals13' version 0: 3664 bytes loaded at 0xc1842810
firmware: 'bwn_v4_lp_lp0initvals14' version 0: 2110 bytes loaded at 0xc1843660
firmware: 'bwn_v4_lp_lp0initvals15' version 0: 2282 bytes loaded at 0xc1843e9e
firmware: 'bwn_v4_lp_lp0bsinitvals13' version 0: 178 bytes loaded at 0xc1844788
firmware: 'bwn_v4_lp_lp0bsinitvals14' version 0: 178 bytes loaded at 0xc184483a
firmware: 'bwn_v4_lp_lp0bsinitvals15' version 0: 178 bytes loaded at 0xc18448ec
firmware: 'bwn_v4_lp_n0bsinitvals11' version 0: 178 bytes loaded at 0xc184499e
siba_bwn0: <Broadcom BCM4312 802.11b/g Wireless> mem 0x57100000-0x57103fff irq 16 at device 0.0 on pci1
bwn0 on siba_bwn0
bwn0: WLAN (chipid 0x4312 rev 15) PHY (analog 6 type 5 rev 1) RADIO (manuf 0x17f ver 0x2062 rev 2)
bwn0: DMA (64 bits)
bwn0: MSI count : 1
siba_bwn0: attempting to allocate 1 MSI vectors (1 supported)
siba_bwn0: using IRQ 257 for MSI
bwn0: Using 1 MSI messages
bwn0: 11b rates: 1Mbps 2Mbps 5.5Mbps 11Mbps
bwn0: 11g rates: 1Mbps 2Mbps 5.5Mbps 11Mbps 6Mbps 9Mbps 12Mbps 18Mbps 24Mbps 36Mbps 48Mbps 54Mbps
bwn0: firmware version (rev 478 patch 104 date 0x8701 time 0x657)
bwn0: need multicast update callback
bwn0: RX decryption attempted (old 0 keyidx 0x3)
bwn0: RX decryption attempted (old 0 keyidx 0x3)
bwn0: RX decryption attempted (old 0 keyidx 0x3)
bwn0: RX decryption attempted (old 0 keyidx 0x3)
bwn0: RX decryption attempted (old 0 keyidx 0x3)
bwn0: RX decryption attempted (old 0 keyidx 0x3)
bwn0: need multicast update callback
bwn0: need multicast update callback
bwn0: RX decryption attempted (old 0 keyidx 0x3)
bwn0: RX decryption attempted (old 0 keyidx 0x3)
bwn0: RX decryption attempted (old 0 keyidx 0x3)
bwn0: RX decryption attempted (old 0 keyidx 0x3)
bwn0: RX decryption attempted (old 0 keyidx 0x3)
bwn0: RX decryption attempted (old 0 keyidx 0x3)
bwn0: RX decryption attempted (old 0 keyidx 0x3)
bwn0: RX decryption attempted (old 0 keyidx 0x3)
bwn0: RX decryption attempted (old 0 keyidx 0x3)
bwn0: RX decryption attempted (old 0 keyidx 0x3)
bwn0: RX decryption attempted (old 0 keyidx 0x3)
bwn0: RX decryption attempted (old 0 keyidx 0x3)
bwn0: RX decryption attempted (old 0 keyidx 0x3)
bwn0: RX decryption attempted (old 0 keyidx 0x3)
bwn0: RX decryption attempted (old 0 keyidx 0x3)
bwn0: RX decryption attempted (old 0 keyidx 0x3)
bwn0: RX decryption attempted (old 0 keyidx 0x3)
bwn0: RX decryption attempted (old 0 keyidx 0x3)
bwn0: RX decryption attempted (old 0 keyidx 0x3)
bwn0: RX decryption attempted (old 0 keyidx 0x3)
-- 
Matthias Apitz               |  /"\   ASCII Ribbon Campaign:
E-mail: guru at unixarea.de     |  \ /   - No HTML/RTF in E-mail
WWW: http://www.unixarea.de/ |   X    - No proprietary attachments
phone: +49-170-4527211       |  / \   - Respect for open standards
                             | en.wikipedia.org/wiki/ASCII_Ribbon_Campaign