FreeBSD with Huawei 3g modem.

[Oliver Pinter]

On 9/23/14, Peter Ankerstål <peter at pean.org> wrote:
> Hi!
>
> Im trying to get a Huawei E3531 to work in FreeBSD. But Im not really
> sure where to start. I found this:
> http://technotation.com/2012/08/15/freebsd-and-mobile-broadband/ but
> havent had any luck cut and pasting here.
>
> System:
> # uname -srm
> FreeBSD 10.0-RELEASE amd64
>
> When I connect it dmesg says:
> usb_alloc_device: Found possible auto-install disk (trying next config)
> ugen0.4: <HUAWEI> at usbus0
> umass0: <HUAWEI HUAWEI Mobile, class 0/0, rev 2.00/1.02, addr 4> on usbus0
> umass0:  SCSI over Bulk-Only; quirks = 0x0000
> umass0:5:0:-1: Attached to scbus5
> da0 at umass-sim0 bus 0 scbus5 target 0 lun 0
> da0: <HUAWEI TF CARD Storage 2.31> Removable Direct Access SCSI-2 device
> da0: Serial Number FFFFFFFFFFFFFFFF
> da0: 40.000MB/s transfers
> da0: Attempt to query device size failed: NOT READY, Medium not present
> da0: quirks=0x2<NO_6_BYTE>
>
> usbconfig gives this:
>
> # usbconfig -u 0 -a 4 dump_device_desc
> ugen0.4: <HUAWEI Mobile HUAWEI> at usbus0, cfg=1 md=HOST spd=HIGH
> (480Mbps) pwr=ON (500mA)
>
>    bLength = 0x0012
>    bDescriptorType = 0x0001
>    bcdUSB = 0x0200
>    bDeviceClass = 0x0000
>    bDeviceSubClass = 0x0000
>    bDeviceProtocol = 0x00ff
>    bMaxPacketSize0 = 0x0040
>    idVendor = 0x12d1
>    idProduct = 0x157d
>    bcdDevice = 0x0102
>    iManufacturer = 0x0001  <HUAWEI>
>    iProduct = 0x0002  <HUAWEI Mobile>
>    iSerialNumber = 0x0003  <FFFFFFFFFFFFFFFF>
>    bNumConfigurations = 0x0002
>
>
>

http://hup.hu/node/122403