KERN - mfi driver for Dell raid h200 on r210 servers

[Garrett Cooper]

On Sat, Jan 29, 2011 at 2:24 PM, Bjoern A. Zeeb
<bzeeb-lists at lists.zabbadoz.net> wrote:
> On Sat, 29 Jan 2011, Damien Fleuriot wrote:
>
>> Hello lists,
>>
>>
>>
>> I'm trying to get FreeBSD 8.0 or 8.1 to run on a Dell poweredge r210
>> server.
>>
>> It ships with a SATA/SAS h200 RAID controller.
>>
>>
>> Sadly, the MFI driver doesn't seem to register for this card...
>>
>>
>> Find below the pciconf -lcvb
>>
>> --
>> none6 at pci0:1:0:0:       class=0x010700 card=0x1f1d1028 chip=0x00721000
>> rev=0x02 hdr=0x00
>>   vendor     = 'LSI Logic (Was: Symbios Logic, NCR)'
>>   class      = mass storage
>>   subclass   = SAS
>>   bar   [10] = type I/O Port, range 32, base 0xfc00, size 256, enabled
>>   bar   [14] = type Memory, range 64, base 0xdf2b0000, size 65536, enabled
>>   bar   [1c] = type Memory, range 64, base 0xdf2c0000, size 262144,
>> enabled
>>   cap 01[50] = powerspec 3  supports D0 D1 D2 D3  current D0
>>   cap 10[68] = PCI-Express 2 endpoint max data 256(4096) link x8(x8)
>>   cap 03[d0] = VPD
>>   cap 05[a8] = MSI supports 1 message, 64 bit
>>   cap 11[c0] = MSI-X supports 15 messages in map 0x14
>> --
>>
>>
>> I have added the following to /usr/src/sys/dev/mfi/mfi_pci.c at line 119:
>> --
>> {0x1000, 0x0072, 0x1028, 0x1f1e, MFI_FLAGS_GEN2,  "Dell PERC H200
>> Integrated"},
>> --
>
> It's 1f1d not 1f1e.  I hope it was only a paste problem into email?

    +1. PERC7 should be supported by mfi(4) (required bits may need to
be added to mfi(4) though as you've pointed out, but additional
details may need to be obtained from Dell).
Thanks,
-Garrett