HP 380 G4 - ciss kernel page fault.

[kama]

On Tue, 27 Apr 2010, kama wrote:

>
> Hi.
>
> I have problem when probing the ciss device. Causing a kernel panic. This
> happened when I upgraded from 6.3 to 7.3-stable. Booting the old kernel
> works. So something has changed. I am also getting the error on both the
> 7.3 and the 8.0 install cd's.
>
> The ciss that causing the problem is a Smart Array 6404 and its the addon
> card that it faults at. The server disconnect it due to an error. But
> since it works on 6.3 it is something that have changed. FreeBSD should
> not panic, it should just disable it.
>
> Also I tried to disable the card in the BIOS, but FreeBSD try to probe it
> anyway and panic.
>
> This whats comes up on a verbose boot through the ILO remote console.
> (typed in manually from a screenshot)
>
> ciss2: <HP Smart Array 6400 EM> port 0x6400-0x64ff mem
> 0xfdf70000-0xfdf71fff irq 98 at device 5.0 on pcill
> ciss2: Reserved 0x2000 bytes for rid 0x10 type 3 at 0xfdf70000
> pci11: child ciss2 requested type 3 for rid 0, but the BAR says it is an
> ioport
> ciss2: can't allocate config window
> kernel trap 12 with interupts disabled
>
> Fatal trap 12: page fault while in kernel mode
> cpuid = 0; apic id = 00
> fault virtual address   = 0xf0009bd0
> fault code              = supervicor write, page not present
> instruction pointer     = 0x20:0xc08b6e99
> stack pointer           = 0x28:0xc1420524
> frame pointer           = 0x28:0xc1420540
> code segment            = base 0x0, limit 0xfffff, type 0x1b
>                         = DPL 0, pres 1, def32, gran 1
> processor eflags        = resume, IOPL = 0
> current process         = 0 (swapper)
> trap number             = 12
> panic: page fault
> cpuid = 0
> Uptime: 1s
> Automatic reboot in 15 seconds - press a key on the console to abort_

I have now tested with all the different official released versions that
are available on the ftps.

6.3 works (was installed on the system)
6.4 works
7.1 panics
7.2 panics
7.3 panics
8.0 panics

I dont know what else to test. The server is 1500 km away, so I cant just
pop down to the datacenter. ILO is my friend right now and I can only boot
on a virtual CD.

I have updated all the firmwares to the latest versions to see if that had
anything to do with it.

/Bjorn