boot failed after make installkernel from 6.3-RELEASE to 7.0-RELEASE

[Lisa Besko]

I've had this very same problem.  I had to go into the kernel config and 
change comment out this line:

options        ATA_STATIC_ID

I may have also had to edit /etc/fstab so that it had the proper device 
name in it.

Then I could rebuild the kernel and it worked.

For me this had to to with the device names not matching up properly and 
after going to the latest version of 7 it would not find the correct 
device names for the drive.

LB

Chih Liang wrote:
> Dear all,
> 
> I've tried to upgrade my FreeBSD server from 6.3-RELEASE to 7.0-RELEASE, 
> but it is failed to boot after make kernel KERNCONF=GENERIC.
> I didn't modify any file at /usr/src/sys/i386/conf, it was all default.
> After done make kernel and reboot, system stop at:
> 
>    Timecounters tick every 1.000 msec
>    ad0: 38166MB <Seagate ST340016A 3.75> at ata0-master UDMA100
> 
> I can't boot in single mode, but I can boot in safe mode, and it showed:
> 
>    Manual root filesystem specification:
>    <fstype>:<device> Mount <device> using filesystem <fstype>
>    eg. ufs:da0s1a
>    ? List valid disk boot devices
>    <empty line> Abort manual input
> 
> I type "?" for list, but it only show acd0 and fdc0, "ufs:ad0s1a" or 
> "ufs:/dev/ad0s1a" are not working
> 
> I can boot with /boot/kernel.old now (6.3-RELEASE), I rebuilt kernel 
> again and again, but still not work.
> I check the difference between old GENERIC on 6.3-RELEASE and new 
> GENERIC on 7.0-RELEASE, it has not difference besides new add in 
> 7.0-RELEASE.
> 
> Is any one can help me? I don't want to reinstall...because I don't have 
> install cd...
> 
> And sorry for my poor English, thank you for reading!
> 
> Regards,
> Chih Liang
> _______________________________________________
> freebsd-stable at freebsd.org mailing list
> http://lists.freebsd.org/mailman/listinfo/freebsd-stable
> To unsubscribe, send any mail to "freebsd-stable-unsubscribe at freebsd.org"