6.3 nfe: strange behavior after hand

[Andriy Gapon]

on 25/02/2008 15:02 Andriy Gapon said the following:
> on 04/02/2008 05:52 Pyun YongHyeon said the following:
>> On Fri, Feb 01, 2008 at 03:56:17PM +0200, Andriy Gapon wrote:
>>  > on 01/02/2008 15:42 Andriy Gapon said the following:
>>  > > on 01/02/2008 14:36 Pyun YongHyeon said the following:
>>  > >> After applying attached patch and let me know the output of
>>  > >> "devid : xxx, revid : xxx, pwr = xxx". It would be even better
>>  > >> if you can show me the above message for working/non-working case.
>>  > >>
>>  > >>
>>  > > 
>>  > > Applied the patch with correction to actually print rev instead of dev
>>  > > for the second time :-)
>>  > > This is in working case:
>>  > > devid : 269, revid : a3, pwr = 00000003
>>  > 
>>  > A clarification: I just applied the patch, recompiled and re-loaded the
>>  > module. There was no reboot/poweroff/reset in between.
>>  > 
>>  > > Will wait for the non-working situation.
>>  > > 
>>  > 
>>
>> Revert previous patch and try attached patch again and let me know
>> how it goes.
>>
>>
> 
> Tried it - still no joy, the behavior is as before.
> If I gracefully reboot the machine or power down and then up, then
> everything is OK. But if I press "reset" button and boot up, the nfe
> interface is "dead".
> BTW, I kept the line for printing devid/revid/pwr and output is the same
> in all cases.
> 

Not sure if that is related but Linux forcedeth driver seems to do some
stuff that we don't do:
http://lxr.linux.no/linux+v2.6.24/drivers/net/forcedeth.c#L5271

-- 
Andriy Gapon