SATA controller memory mapping

[Wilko Bulte]

On Fri, Dec 30, 2005 at 02:05:37PM +0000, Bill Smith wrote..
> The only little glitch in my 6.0-Stable system is this:
> 
> atapci1: <Intel ICH5 SATA150 controller> port 
> 0xa800-0xa807,0xa400-0xa403,0xa000
> -0xa007,0x9800-0x9803,0x9400-0x940f irq 18 at device 31.2 on pci0
> atapci1: failed to enable memory mapping!
> 
> I am not using this for booting off right now but will be at some time 
> in the future, is there something I can do to enable the memory mapping 
> for it, or should I just ignore it.
> It is on an Asus P5P800.

P4P800 I guess?

I have seen the same message on my P4P800 ever since I own it (I think).
It ran 4-stable before.  Works fine so I would not worry about it if I were
you.

-- 
Wilko Bulte				wilko at FreeBSD.org