USB2 device

[Michael E. Mercer]

RELENG_4

On Sat, 2004-03-27 at 19:07, Julian Elischer wrote:
> Michael E. Mercer wrote:
> > Julian,
> > 
> > I am running 4.9-Stable. I do not see EHCI in the LINT file and config
> > on a kernel config file says unknown ehci device.
> 
> what tag are you checking your code out on?
> 
> 
> > 
> > Any ideas?
> > 
> > Thanks
> > Michael E Mercer
> > 
> > 
> > On Sat, 2004-03-27 at 18:53, Julian Elischer wrote:
> > 
> >>Julian Elischer wrote:
> >>
> >>> I have the same Lexar Jumpdrive and it seems to work for me on an Asus 
> >>>P4PE
> >>>with intel EHCI driver, as long as I plug it in AFTER booting.
> >>>
> >>>however:
> >>>It hangs if I have the drive in during boot.
> >>>It doesn't seem to give me the speed I get on another system
> >>>
> >>>BTW the speeds are:
> >>>
> >>>low speed (1.5Mb/Sec)
> >>>
> >>>full speed (12Mb/sec)
> >>>
> >>>high speed (480Mb/sec)
> >>>
> >>>
> >>>I'm working on the USB code at the moment so I'm hoping to gete it fixed.
> >>
> >>I forgot to say that you need to configure the EHCI driver into our kernel
> >>or you can not get USB2.
> >>I notice it is not in your kernel dmesg..
> >>
> >>
> >>>-- original message:
> >>>
> >>>Hello,
> >>>
> >>>
> >>>>I have an ASUS P4C-800-E Deluxe Motherboard, P4 3.0GHz processor with 
> >>>>builtin
> >>>>USB 2.0 controllers.
> >>>>
> >>>>I am having a problem with the Lexar Media JumpDrive 2.0 Pro 256M 
> >>>>memory keystick.
> >>>>
> >>>>usbd nevers sees it. I finally went into BIOS and set the Speed for 
> >>>>the USB
> >>>>2.0  Controller to FullSpeed (maybe HighSpeed, in whatever case its 
> >>>>12MBps as
> >>>>opposed to 240MBps). When setting it to 12MBps, usbd sees the drive and
> >>>>attaches it. Setting the speed to higher, usbd does NOT attach it.
> >>>>
> >>>
> >>>I don't know how the Bios is connecte with this...
> >>>
> >>>
> >>>>Also NOTE: I have a SIIG SlimHub 2.0 4 ports, that I can not attach my 
> >>>>JumpDrive too. I must set the speed to 12MBps and attach it directly to a
> >>>>port on my PC to get it to see it.
> >>>>
> >>>>Any help in this would be appreciated.
> >>>>
> >>>>Thanks! Michael E. Mercer
> >>>>
> >>>>My system is the latest 4.9-Stable build as of yesterday.
> >>>
> >>>
> >>>I committed some relevant stuff yesterday. make sure you have that..
> >>>
> >>
> > 
> > 
>