sparc64 r228561 panic: kmem_suballoc: bad status return of 3
Anton Shterenlikht
mexas at bristol.ac.uk
Fri Dec 16 10:16:58 UTC 2011
On Fri, Dec 16, 2011 at 10:24:44AM +0100, Monthadar Al Jaberi wrote:
> Hi,
>
> do you get your panic at early in the boot stage?
yes, the panic is straight after
WARNING: WITNESS option enabled, expect reduced performance.
> I get the same message on arm when I set the DEBUG_MEMGUARD flag early
> on bootup:
I don't have this in kernel config.
> Nov 24 201018:40:27
> poweron_pll
> EMI_CTRL 0x1C084040
> FRAC 0x92926192
> init_clock
> init_ddr_mt46v32m16_133Mhz
> exit self refresh timeout
> power 0x00310710
> Frac 0x92926192
> start change cpu freq
> hbus 0x00000003
> cpu 0x00010001
> KDB: debugger backends: ddb
> KDB: current backend: ddb
> Copyright (c) 1992-2011 The FreeBSD Project.
> Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
> \0x09The Rege
> nts of the University of California. All rights reserved.
> FreeBSD is a registered trademark of The FreeBSD Foundation.
> FreeBSD 10.0-CURRENT #948: Thu Dec 15 16:45:14 UTC 2011
> root at bsd.ab:/usr/obj/arm.arm/usr/src/sys/ARM arm
> WARNING: WITNESS option enabled, expect reduced performance.
> WARNING: DIAGNOSTIC option enabled, expect reduced performance.
> MEMGUARD DEBUGGING ALLOCATOR INITIALIZED:
> \0x09MEMGUARD map base: 0xc0e8b000
> \0x09MEMGUARD map lim
> it: 0xc790b000
> \0x09MEMGUARD map size: 109056 KBytes
> CPU: ARM926EJ-S rev 5 (ARM9EJ-S core)
> DC enabled IC enabled WB enabled LABT
> 16KB/32B 4-way Instruction cache
> 16KB/32B 4-way write-back-locking-C Data cache
> real memory = 67108864 (64 MB)
> panic: kmem_suballoc: bad status return of 3
> KDB: enter: panic
>
> br,
>
> On Fri, Dec 16, 2011 at 9:40 AM, Anton Shterenlikht <mexas at bristol.ac.uk> wrote:
> > Updating from r216048 to r228561 on sparc64,
> > with sys/conf/newvers.sh changed to REVISION="9.9".
> >
> > Trinscribed by hand:
> >
> > FreeBSD 9.9-CURRENT #3 r228561M:
> >
> > panic: kmem_suballoc: bad status return of 3
> > KDB: enter: panic
> > [ thread pid 0 tid 0 ]
> > The keyboard froze, couldn't get a bt,
> > required a cold reboot.
> >
> > My /etc/make.conf and kernel config files are below.
> >
> > Any advice?
> >
> > Many thanks
> > Anton
> >
> >
> >
> >
> > % cat /etc/make.conf
> > # Add SMTP AUTH support to Sendmail
> > SENDMAIL_CFLAGS+= -I/usr/local/include -DSASL=2
> > # added by use.perl 2011-11-15 09:47:38
> > PERL_VERSION=5.14.1
> >
> > % cat /root/kernels/QOF
> >
> > makeoptions DEBUG=-g
> > makeoptions MODULES_OVERRIDE="geom/geom_part geom/geom_label opensolaris zfs"
> >
> > options ALT_BREAK_TO_DEBUGGER
> > options BREAK_TO_DEBUGGER
> > options CD9660
> > options DDB
> > #options EXCEPTION_TRACING
> > options FFS
> > options GDB
> > options INET
> > options INET6
> > options INVARIANTS
> > options INVARIANT_SUPPORT
> > #options IPI_PREEMPTION
> > options KDB
> > options KTRACE
> > options MD_ROOT
> > options MSDOSFS
> > options NFSCLIENT
> > options NFSLOCKD
> > options P1003_1B_SEMAPHORES
> > #options PREEMPTION
> > options PRINTF_BUFR_SIZE=128
> > options PROCFS
> > options PSEUDOFS
> > options SCHED_4BSD
> > #options SCHED_ULE
> > options SCSI_DELAY=3000
> > options SCTP # Stream Control Transmission Protocol
> > options SOFTUPDATES
> > options SYSVMSG
> > options SYSVSEM
> > options SYSVSHM
> > options UFS_DIRHASH
> > #options UWX_TRACE_ENABLE
> > options WITNESS
> > #options WITNESS_KDB
> > options WITNESS_SKIPSPIN
> > options _KPOSIX_PRIORITY_SCHEDULING
> >
> > options COMPAT_43TTY # BSD 4.3 TTY compat (sgtty)
> > options STACK # stack(9) support
> > options HWPMC_HOOKS # Necessary kernel hooks for hwpmc(4)
> > options KBD_INSTALL_CDEV # install a CDEV entry in /dev
> >
> > device ata
> > device atadisk
> > device atapicd
> > device atapicam
> > device auxio
> > device bge
> > device bpf
> > device cd
> > device da
> > device ebus
> > device eeprom # eeprom (really a front-end for the MK48Txx)
> > device ehci
> > device ether # Ethernet support
> > device firmware # firmware assist module
> > device isa
> > device loop # Network loopback
> > device lpt
> > device machfb # ATI Mach64 framebuffers
> > device mc146818 # Motorola MC146818 and compatible clocks
> > device md
> > device miibus # MII bus support
> > device mk48txx # Mostek MK48Txx clocks
> > device ohci
> > device pass
> > device pci
> > device pty # BSD-style compatibility pseudo ttys
> > device puc # Multi-channel uarts
> > device ppbus
> > device ppc
> > device random # Entropy device
> > device rtc # rtc (really a front-end for the MC146818)
> > device sbus
> > device sc
> > device scbus # SCSI bus (required for SCSI)
> > device scc # Serial communications controllers.
> > device snd_audiocs
> > device snd_t4dwave
> > device sound
> > device tun # Packet tunnel.
> > device uart # Multi-uart driver
> > device uhci
> > device ukbd # Keyboard
> > device umass
> > device ums # Mouse
> > device usb
> >
> > --
> > Anton Shterenlikht
> > Room 2.6, Queen's Building
> > Mech Eng Dept
> > Bristol University
> > University Walk, Bristol BS8 1TR, UK
> > Tel: +44 (0)117 331 5944
> > Fax: +44 (0)117 929 4423
> > _______________________________________________
> > freebsd-current at freebsd.org mailing list
> > http://lists.freebsd.org/mailman/listinfo/freebsd-current
> > To unsubscribe, send any mail to "freebsd-current-unsubscribe at freebsd.org"
>
>
>
> --
> Monthadar Al Jaberi
> _______________________________________________
> freebsd-current at freebsd.org mailing list
> http://lists.freebsd.org/mailman/listinfo/freebsd-current
> To unsubscribe, send any mail to "freebsd-current-unsubscribe at freebsd.org"
>
--
Anton Shterenlikht
Room 2.6, Queen's Building
Mech Eng Dept
Bristol University
University Walk, Bristol BS8 1TR, UK
Tel: +44 (0)117 331 5944
Fax: +44 (0)117 929 4423
More information about the freebsd-sparc64
mailing list