installing freebsd on b100 blade -- STUCK !!

Marius Strobl marius at alchemy.franken.de
Tue Jul 1 10:38:33 UTC 2008


On Mon, Jun 30, 2008 at 11:37:09PM +0100, Craig Butler wrote:
> Hi Guys,
> 
> Am stuck trying to install FreeBSD 7 on a sparc B100 sitting in a B1600
> chassis.
> 
> Any help would be appreciated....
> 
> b1600-01bootmode bootscript="boot net" s0
> b1600-01reset s0
> Are you sure you want to reset S0 (y/n)? y
> Reset of S0 successful
> b1600-01console s0
> [Connected with input enabled on fru S0]
> Escape Sequence is '#.'
> Probing Memory Bank #0 512 Megabytes
> Probing Memory Bank #1 512 Megabytes
> Probing Memory Bank #2   0 Megabytes
> Probing Memory Bank #3   0 Megabytes
> No clientid supplied by the BSC.
> Sun Serverblade1 (UltraSPARC-IIe 650MHz), No Keyboard
> Copyright 1998-2002 Sun Microsystems, Inc.  All rights reserved.
> OpenBoot  4.7.5, 1024 MB memory installed, Serial #52823543.
> Ethernet address 0:3:ba:2a:11:b8, Host ID: 832605f7.
> 
> 
> 
> Boot device: /pci at 1f,0/network at a  File and args:
> 1000 Mbps FDXLink up
> 36800
> Server IP address: 10.0.0.10
> Client IP address: 10.0.0.20
> Consoles: Open Firmware console
> 
> Booting with sun4u support.
> 
> FreeBSD/sparc64 bootstrap loader, Revision 1.0
> (root at obrian.cse.buffalo.edu, Sun Feb 24 17:36:50 UTC 2008)
> bootpath="/pci at 1f,0/network at a"
> boot: ethernet address: 00:03:ba:2a:11:b8
> 1000 Mbps FDXLink up
> net_open: server addr: 10.0.0.10
> net_open: server path: /tftpboot
> Loading /boot/defaults/loader.conf
> /boot/kernel/kernel data=0x6f0848+0x72c68 syms=[0x8+0x76920+0x8+0x6668e]
> \
> Hit [Enter] to boot immediately, or any other key for command prompt.
> Booting [/boot/kernel/kernel] in 9 seconds...
> 
> Type '?' for a list of commands, 'help' for more detailed help.
> 
> OK set console
> Available consoles:
>     ofw
> operation not permitted
> OK help set console
> /
>         set console[=<value>]
> 
>         Sets the current console.  If <value> is omitted, a list of
> valid
> -       consoles will be displayed.
> 
> OK set console=ofw
> OK boot
> nothing to autoload yet.
> jumping to kernel entry at 0xc0070000.
> Copyright (c) 1992-2008 The FreeBSD Project.
> Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
>         The Regents of the University of California. All rights
> reserved.
> FreeBSD is a registered trademark of The FreeBSD Foundation.
> FreeBSD 7.0-RELEASE #0: Mon Feb 25 09:35:41 UTC 2008
>     root at obrian.cse.buffalo.edu:/usr/obj/usr/src/sys/GENERIC
> Timecounter "tick" frequency 650000000 Hz quality 1000
> real memory  = 1073741824 (1024 MB)
> avail memory = 1027727360 (980 MB)
> cpu0: Sun Microsystems UltraSparc-IIe Processor (650.00 MHz CPU)
> registered firmware set <isp_1000>
> registered firmware set <isp_1040>
> registered firmware set <isp_1040_it>
> registered firmware set <isp_1080>
> registered firmware set <isp_1080_it>
> registered firmware set <isp_12160>
> registered firmware set <isp_12160_it>
> registered firmware set <isp_2100>
> registered firmware set <isp_2200>
> registered firmware set <isp_2300>
> registered firmware set <isp_2322>
> registered firmware set <isp_2400>
> ath_hal: 0.9.20.3 (AR5210, AR5211, AR5212, RF5111, RF5112, RF2413,
> RF5413, REGOPS_FUNC)
> nexus0: <Open Firmware Nexus device>
> pcib0: <U2P UPA-PCI bridge> mem
> 0x1fe00000000-0x1fe0000ffff,0x1fe01000000-0x1fe010000ff irq
> 2032,2030,2031,2021 on nexus0
> pcib0: Hummingbird compatible, impl 0, version 0, IGN 0x1f, bus A
> pcib0: [FILTER]
> pcib0: [FILTER]
> pcib0: [GIANT-LOCKED]
> pcib0: [ITHREAD]
> pcib0 dvma: DVMA map: 0xc0000000 to 0xc3ffffff
> pcib0: [FILTER]
> pci0: <OFW PCI bus> on pcib0
> isab0: <PCI-ISA bridge> at device 7.0 on pci0
> isa_setup_children: no PnP map entry for node 0xf006f7b8: bscbus
> isa0: <ISA bus> on isab0
> pci0: <old, non-VGA display device> at device 3.0 (no driver attached)
> pci0: <network, ethernet> at device 10.0 (no driver attached)
> pci0: <network, ethernet> at device 11.0 (no driver attached)
> atapci0: <AcerLabs M5229 UDMA100 controller> port
> 0x900-0x907,0x918-0x91b,0x910-0x917,0x908-0x90b,0x920-0x92f at device
> 13.0 on pci0
> atapci0: [ITHREAD]
> atapci0: using PIO transfers above 137GB as workaround for 48bit DMA
> access bug, expect reduced performance
> ata2: <ATA channel 0> on atapci0
> ata2: [ITHREAD]
> ata3: <ATA channel 1> on atapci0
> ata3: [ITHREAD]
> nexus0: <syscons> type unknown (no driver attached)
> 
> At this point it just hangs..... any clues ?
> 

Could you please provide the output of a verbose boot and if
possible also the Open Firmware device tree dump done under
f.e. Solaris?

Marius



More information about the freebsd-sparc64 mailing list