extended tabled hosed on Proliant

nycvelo at earthlink.net nycvelo at earthlink.net
Thu Jul 10 07:25:11 PDT 2003

Apologies if this has been asked before. I've installed 4.8 on a Compaq Proliant 1850 6-550 and built a kernel with MP support. The system boots the MP kernel OK, but mptable reports "Extended Table HOSED!"

I don't see anything unusual in dmesg, but I may be missing something. Output of dmesg and mptable below.

Thanks very much for any ideas on how to fix this. 

David Newman

dnewman at moser ~ 81$ dmesg
Copyright (c) 1992-2003 The FreeBSD Project.
Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
        The Regents of the University of California. All rights reserved.
FreeBSD 4.8-STABLE #1: Fri Jul  4 11:51:56 PDT 2003
    root at moser.int.networktest.com:/usr/obj/usr/src/sys/SMPKERN
Timecounter "i8254"  frequency 1193182 Hz
CPU: Pentium III/Pentium III Xeon/Celeron (548.34-MHz 686-class CPU)
  Origin = "GenuineIntel"  Id = 0x673  Stepping = 3
real memory  = 536854528 (524272K bytes)
avail memory = 517677056 (505544K bytes)
Changing APIC ID for IO APIC #0 from 0 to 8 on chip
Programming 35 pins in IOAPIC #0
IOAPIC #0 intpin 2 -> irq 0
FreeBSD/SMP: Multiprocessor motherboard
 cpu0 (BSP): apic id:  1, version: 0x00040011, at 0xfee00000
 cpu1 (AP):  apic id:  0, version: 0x00040011, at 0xfee00000
 io0 (APIC): apic id:  8, version: 0x00220011, at 0xfec00000
Preloaded elf kernel "kernel" at 0xc0490000.
Pentium Pro MTRR support enabled
md0: Malloc disk
npx0: <math processor> on motherboard
npx0: INT 16 interface
pcib0: <Intel 82443BX host to PCI bridge (AGP disabled)> on motherboard
pci0: <PCI bus> on pcib0
sym0: <875> port 0x2000-0x20ff mem 0xc6eff000-0xc6efffff,0xc6efcf00-0xc6efcfff irq 10 at device 6.0 on pci0
sym0: No NVRAM, ID 7, Fast-20, SE, parity checking
sym1: <875> port 0x2400-0x24ff mem 0xc6efe000-0xc6efefff,0xc6efce00-0xc6efceff irq 11 at device 6.1 on pci0
sym1: No NVRAM, ID 7, Fast-20, SE, parity checking
tl0: <Compaq Netelligent 10/100 Proliant> port 0x2c20-0x2c2f mem 0xc6efccf0-0xc6efccff irq 15 at device 7.0 on pci0
tl0: Ethernet address: 00:50:8b:8f:b9:f1
miibus0: <MII bus> on tl0
lxtphy0: <LXT970 10/100 media interface> on miibus0
lxtphy0:  100baseFX, 100baseFX-FDX, 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
tlphy0: <ThunderLAN 10baseT media interface> on miibus0
tlphy0:  10base2/BNC, 10base5/AUI
pci0: <ATI Mach64-GV graphics accelerator> at 8.0
pci0: <unknown card> (vendor=0x0e11, dev=0xa0f0) at 9.0
fxp0: <Intel 82557/8/9 EtherExpress Pro/100(B) Ethernet> port 0x2c00-0x2c1f mem 0xc6f00000-0xc6ffffff,0xc4fff000-0xc4ffffff irq 5 at device 15.0 on pci0
fxp0: Ethernet address 00:50:8b:6a:93:cf
inphy0: <i82555 10/100 media interface> on miibus1
inphy0:  10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
isab0: <Intel 82371AB PCI to ISA bridge> at device 20.0 on pci0
isa0: <ISA bus> on isab0
atapci0: <Intel PIIX4 ATA33 controller> port 0xf100-0xf10f at device 20.1 on pci0
ata0: at 0x1f0 irq 14 on atapci0
ata1: at 0x170 irq 15 on atapci0
pci0: <Intel 82371AB/EB (PIIX4) USB controller> at 20.2 irq 0
piix0: <Intel 82371AB Power management controller> at device 20.3 on pci0
eisa0: <EISA bus> on motherboard
mainboard0: <CPQ0679 (System Board)> on eisa0 slot 0
orm0: <Option ROMs> at iomem 0xc0000-0xc7fff,0xe8000-0xedfff,0xee000-0xeffff on isa0
fdc0: <NEC 72065B or clone> at port 0x3f0-0x3f5,0x3f7 irq 6 drq 2 on isa0
fdc0: FIFO enabled, 8 bytes threshold
fd0: <1440-KB 3.5" drive> on fdc0 drive 0
atkbdc0: <Keyboard controller (i8042)> at port 0x60,0x64 on isa0
atkbd0: <AT Keyboard> flags 0x1 irq 1 on atkbdc0
kbd0 at atkbd0
vga0: <Generic ISA VGA> at port 0x3c0-0x3df iomem 0xa0000-0xbffff on isa0
sc0: <System console> at flags 0x100 on isa0
sc0: VGA <16 virtual consoles, flags=0x300>
sio0 at port 0x3f8-0x3ff irq 4 flags 0x10 on isa0
sio0: type 16550A
sio1 at port 0x2f8-0x2ff irq 3 on isa0
sio1: type 16550A
ppc0: cannot reserve I/O port range
APIC_IO: Testing 8254 interrupt delivery
APIC_IO: routing 8254 via IOAPIC #0 intpin 2
ata0-slave: ATAPI identify retries exceeded
SMP: AP CPU #1 Launched!
acd0: CDROM <CD-224E> at ata0-master PIO4
Waiting 15 seconds for SCSI devices to settle
Mounting root from ufs:/dev/da0s1a
da0 at sym0 bus 0 target 0 lun 0
da0: <COMPAQ BD009122BA 3B07> Fixed Direct Access SCSI-2 device 
da0: 40.000MB/s transfers (20.000MHz, offset 15, 16bit), Tagged Queueing Enabled
da0: 8678MB (17773524 512 byte sectors: 255H 63S/T 1106C)
da1 at sym0 bus 0 target 1 lun 0
da1: <COMPAQ BD009122BA 3B07> Fixed Direct Access SCSI-2 device 
da1: 40.000MB/s transfers (20.000MHz, offset 15, 16bit), Tagged Queueing Enabled
da1: 8678MB (17773524 512 byte sectors: 255H 63S/T 1106C)

dnewman at moser ~ 82$ sudo mptable


MPTable, version 2.0.15


MP Floating Pointer Structure:

  location:                     BIOS
  physical address:             0x000f4ff0
  signature:                    '_MP_'
  length:                       16 bytes
  version:                      1.4
  checksum:                     0x17
  mode:                         Virtual Wire


MP Config Table Header:

  physical address:             0x000f2c4e
  signature:                    'PCMP'
  base table length:            252
  version:                      1.4
  checksum:                     0x17
  OEM ID:                       'COMPAQ  '
  Product ID:                   'PROLIANT    '
  OEM table pointer:            0x00000000
  OEM table size:               0
  entry count:                  23
  local APIC address:           0xfee00000
  extended table length:        76
  extended table checksum:      86


MP Config Base Table Entries:

Processors:     APIC ID Version State           Family  Model   Step    Flags
                 1       0x10    BSP, usable     6       7       3       0x383fbff
                 0       0x10    AP, usable      6       7       3       0x383fbff
Bus:            Bus ID  Type
                 0       PCI   
                 9       ISA   
I/O APICs:      APIC ID Version State           Address
                 8       0x11    usable          0xfec00000
I/O Ints:       Type    Polarity    Trigger     Bus ID   IRQ    APIC ID PIN#
                INT     active-hi        edge        9     1          8    1
                INT     active-hi        edge        9     0          8    2
                INT     active-hi        edge        9     3          8    3
                INT     active-hi        edge        9     4          8    4
                INT     active-hi       level        9     5          8    5
                INT     active-hi        edge        9     6          8    6
                INT     active-hi        edge        9     7          8    7
                INT     active-hi        edge        9     8          8    8
                INT     active-hi       level        9     9          8    9
                INT     active-hi       level        9    10          8   10
                INT     active-hi       level        9    11          8   11
                INT     active-hi        edge        9    12          8   12
                INT     active-lo        edge        9    13          8   13
                INT     active-hi        edge        9    14          8   14
                INT     active-hi       level        9    15          8   15
Local Ints:     Type    Polarity    Trigger     Bus ID   IRQ    APIC ID PIN#
                ExtINT   conforms    conforms        9     0        255    0
                NMI      conforms    conforms        9     0        255    1


MP Config Extended Table Entries:

Extended Table HOSED!

More information about the freebsd-smp mailing list