WIFI as access point
Ernie Luzar
luzar722 at gmail.com
Thu Mar 16 00:49:05 UTC 2017
Peter Pauly wrote:
> Do you need:
>
> sysctl net.inet.ip.forwarding=1
gateway_enable="YES" sets net.inet.ip.forwarding to 1
>
> On Wed, Mar 15, 2017 at 8:36 PM, Peter Pauly <ppauly at gmail.com
> <mailto:ppauly at gmail.com>> wrote:
>
> Nevermind - I see the: gateway_enable="YES"
>
> On Wed, Mar 15, 2017 at 8:31 PM, Peter Pauly <ppauly at gmail.com
> <mailto:ppauly at gmail.com>> wrote:
>
> How are you routing packets between the two interfaces?
>
> On Wed, Mar 15, 2017 at 8:18 PM, Ernie Luzar <luzar722 at gmail.com
> <mailto:luzar722 at gmail.com>> wrote:
>
> On Wed, Mar 15, 2017 at 12:18 PM, Ernie Luzar
> <luzar722 at gmail.com <mailto:luzar722 at gmail.com>
> <mailto:luzar722 at gmail.com <mailto:luzar722 at gmail.com>>>
> wrote:
>
> Dima Panov wrote:
>
>
> Ernie Luzar wrote:
>
> Hello List;
>
> I have this wifi card
>
> http://www.dlink.com/al/sq/products/dwa-556-xtreme-n-pci-express-desktop-adapter
> <http://www.dlink.com/al/sq/products/dwa-556-xtreme-n-pci-express-desktop-adapter>
>
> <http://www.dlink.com/al/sq/products/dwa-556-xtreme-n-pci-express-desktop-adapter
> <http://www.dlink.com/al/sq/products/dwa-556-xtreme-n-pci-express-desktop-adapter>>
>
>
> I recovered it from a decommissioned win7
> box. On win7 this
> wifi card
> could only be used to connect to a router
> access point.
>
> If I add this wifi card to my FreeBSD 11.0
> system can it be
> configured
> to function as an access point?
>
>
> This card is fully support by ath driver as
> "AR5418 Wireless Network
> Adapter".
> Copmlete examples with various AP setup
> described in manual page
> for driver.
>
>
>
> I have followed the handbook "30.3.6 Freebsd Host
> Access Points"
> Chapter in setting up this ath0 wifi card that is
> installed into my
> gateway box that has a LAN on it. A win7 laptop can
> see the ssid and
> connect to it. But it can not gain public internet
> access. Win7 wifi
> trouble shooting says no valid ip address and not
> end point. To me
> this sounds like a network configuration problem on
> my Freebsd
> gateway box.
>
> /root >ifconfig wlan0
> wlan0:
> flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST>
> metric 0 mtu 0
> ether 00:18:e7:d5:b3:84
> inet 10.0.10.100 netmask 0xffffff00
> broadcast 10.0.10.255
> nd6
> options=29<PERFORMNUD,IFDISABLED,AUTO_LINKLOCAL>
> media: IEEE 802.11 Wireless Ethernet
> autoselect mode 11ng
> <hostap>
> status: running
> ssid FBSD_AP channel 1 (2412 MHz 11g ht/40+)
> bssid
> 00:18:e7:d5:b3:84
> regdomain FCC indoor ecm authmode
> WPA2/802.11i privacy MIXED
> deftxkey 3 AES-CCM 2:128-bit AES-CCM
> 3:128-bit txpower 27
> scanvalid 60
> protmode CTS ampdulimit 64k ampdudensity 8
> shortgi wme burst
> dtimperiod 1 -dfs
> groups: wlan
>
>
>
> /root >cat /etc/hostapd.conf
> interface=wlan0
> debug=2
> ctrl_interface=/var/run/hostapd
> ctrl_interface_group=wheel
> ssid=FBSD_AP
> wpa=2
> wpa_passphrase=test
> wpa_key_mgmt=WPA-PSK
> wpa_pairwise=CCMP
>
>
> /root >cat /etc/rc.conf
> Snip
>
> gateway_enable="YES"
>
> ifconfig_em0="DHCP" # from cable modem
> ifconfig_vge0="inet 10.0.10.2" # to LAN switch
>
> # Wifi in hostap mode
> wlans_ath0="wlan0"
> create_args_wlan0="wlanmode hostap"
> ifconfig_wlan0="inet 10.0.10.100 netmask
> 255.255.255.0 ssid FBSD_AP
> mode 11g"
> hostapd_enable="YES"
>
> dhcpd_enable="YES"
> dhcpd_conf="/usr/local/etc/dhcpd.conf"
> dhcpd_ifaces="vge0" # ASRock Server Lan Nic
> dhcpd_flags="-q"
>
>
> This general config has been working for many years,
> since release
> 3.0 of Freebsd. The only thing new is the wifi card
> being used as a
> gateway hostap.
>
> I do not understand what this is doing
> fconfig_wlan0="inet 10.0.10.100 netmask 255.255.255.0
>
> I can not find any documentation on this as to it's
> purpose.
>
> I am trying to duplucate my cisco wifi router config
> which has this
> security mode = wpa2 personal
> encrytion = tkip or aes
> network mode = BGN
>
>
> Thanks for any help you can give me
>
>
> Peter Pauly wrote:
> You're serving DHCP on your LAN interface, but not on
> the WiFi interface.
>
>
> Thanks I corrected that now.
>
> Now the win7 wifi stays connected but has no internet access.
>
> /root >ifconfig wlan0 list scan
> ADDR AID CHAN RATE RSSI IDLE TXSEQ RXSEQ
> CAPS FLAG
> 0c:ee:e6:ba:6f:26 1 1 54M 26.5 135 16 8288
> EPS AQE RSN WME
>
> I also see a dhcp lease for the ip address that win7 wifi
> says it has.
>
> What can be the cause of no internet access on the wifi hostap?
>
>
>
>
>
>
>
More information about the freebsd-questions
mailing list