trouble installing to sun blade 1500

[Gheorghe Ardelean]

On Tue, 1 Dec 2009, Anton Shterenlikht wrote:

> On Tue, Dec 01, 2009 at 05:27:11PM +0100, Gheorghe Ardelean wrote:
>>
>>
>> Hello Anton ... to FreeBSD sparc64,
>>
>>> I get to OK prompt, type "boot cdrom", but the process
>>> stops after a few seconds with:
>>>
>>> 	jumping to kernel entry at 0xc0088000.
>>>
>>
>> I think supported system means that it is working at least via serial
>> console (this is the case e.g for Plain Ultra 1).
>>
>> So when I see something like this I hook-up a serial console and try over
>> it.
>
> ok, 8.0 installation went fine.
>
> On reboot I get this panic (typed by hand):
>
> 	Entropy harvesting: interrupts ethernet point_to_pointpanic: trap: memory
> 	address not aligned
>
> 	Automatic reboot in 15 seconds
>
> Any advice?

Maybe marius@ can help you.

But I would also give 7.2 a try. 7.2-RELEASE was the first release to 
support Blade 1500 IIRC.

Regards,

Gheorghe Ardelean.