trouble installing to sun blade 1500

[Anton Shterenlikht]

On Tue, Dec 01, 2009 at 04:57:52PM +0000, Anton Shterenlikht wrote:
> On Tue, Dec 01, 2009 at 05:27:11PM +0100, Gheorghe Ardelean wrote:
> > 
> > 
> > Hello Anton ... to FreeBSD sparc64,
> > 
> > > I get to OK prompt, type "boot cdrom", but the process
> > > stops after a few seconds with:
> > >
> > > 	jumping to kernel entry at 0xc0088000.
> > >
> > 
> > I think supported system means that it is working at least via serial 
> > console (this is the case e.g for Plain Ultra 1).
> > 
> > So when I see something like this I hook-up a serial console and try over 
> > it.
> 
> ok, 8.0 installation went fine.
> 
> On reboot I get this panic (typed by hand):
> 
> 	Entropy harvesting: interrupts ethernet point_to_pointpanic: trap: memory
> 	address not aligned
> 
> 	Automatic reboot in 15 seconds
> 
> Any advice?

in case it matters, I see

	nexus0: <syscons> type unknown (no driver attached)

	nexus0: <memory-controller> mem 0x40000000000-0x4000000007 type
	memory-controller (no driver attached)

messages on boot.

Not sure if it's related.

many thanks for any advice


-- 
Anton Shterenlikht
Room 2.6, Queen's Building
Mech Eng Dept
Bristol University
University Walk, Bristol BS8 1TR, UK
Tel: +44 (0)117 331 5944
Fax: +44 (0)117 929 4423