dmesg not working on new system

[Chris Maness]

I just installed 6.1 and upgraded to RELEASE-p1.  The command dmesg is 
not displaying any kernel messages, any suggestions?  I am running a 
SCSI hard drive on this box too.

Here is a snipit from the message log in case these issues have anything 
to do with it.


Timecounter "TSC" frequency 669103956 Hz quality 800
Jun  5 06:55:12 ns2 kernel: Timecounters tick every 1.000 msec
Jun  5 06:55:12 ns2 kernel: Waiting 5 seconds for SCSI devices to settle
Jun  5 06:55:12 ns2 kernel: acd0: CDROM <CREATIVE CD5230E/C1.01> at 
ata1-master
PIO4
Jun  5 06:55:12 ns2 kernel: da0 at ahc0 bus 0 target 6 lun 0
Jun  5 06:55:12 ns2 kernel: da0: <QUANTUM ATLAS 10K 18WLS UCP0> Fixed 
Direct Acc
ess SCSI-3 device
Jun  5 06:55:12 ns2 kernel: da0: 160.000MB/s transfers (80.000MHz, 
offset 31, 16
bit), Tagged Queueing Enabled
Jun  5 06:55:12 ns2 kernel: da0: 17518MB (35877972 512 byte sectors: 
255H 63S/T
2233C)
Jun  5 06:55:12 ns2 kernel: Trying to mount root from ufs:/dev/da0s1a
Jun  5 06:55:12 ns2 kernel: dc0: failed to force tx and rx to idle state
Jun  5 06:55:12 ns2 kernel: dc0: failed to force tx and rx to idle state