re-installing applications using ports
Gerard Seibert
gerard at seibercom.net
Fri Dec 23 03:48:37 PST 2005
On Friday, December 23, 2005 6:00:15 AM
Robert Stevenson <robsworld2000 at yahoo.com>
Subject: re-installing applications using ports
Wrote these words of wisdom:
> I have begun an installation using the ports
> collection but later I decided to cancel it so I could
> change some install options. When I start installation
> again I get the message " Found saved configuration
> for ..... " then immediately begins compiling. I could
> no longer see the installation menu where I could set
> the options.
>
> The questions is, how do I re-initialize the
> installation process so I could go to the installation
> menu once more and set the options?
***** REPLY SEPARATOR *****
On 10/11/2005 5:29:42 PM, Gerard Replied:
I would use: 'make distclean' to clean out everything that you started
doing.
Then I believe you can use this:
make config
or
make config-recursive
to reconfigure the port. The latter might be the better way for you.
--
Gerard Seibert
gerard at seibercom.net
More information about the freebsd-questions
mailing list