xorg -configure: command not found

[Dustin]

When I run any one of those commands, I get a "command not found message".
 
I followed the instructions in the handbook to a tee, not sure what's going on.
 
Just to refresh, it's a FreeBSD 5.2.1-REL (Fresh Install), kern-developer option, updated ports tree using cvsup, ran portupgrade, etc..
 
Dustin

	-----Original Message----- 
	From: Chris [mailto:racerx at makeworld.com] 
	Sent: Mon 9/6/2004 5:35 PM 
	To: Dustin 
	Cc: freebsd-questions at freebsd.org 
	Subject: Re: xorg -configure: command not found
	
	

	Dustin wrote:
	> Probably a stupid question but, just installed xorg from ports, ran 'rehash', and attempted to run 'Xorg -configure', but get:
	> 
	> Xorg: Command not found.
	> 
	> I added 'X_WINDOW_SYSTEM=xorg' to make.conf even though XFree86 was never installed on this system.
	> 
	> What am I missing?
	>
	
	2 things -
	
	1. startx ought to start X and bring you into your WM of choice.
	2. To configure X itself,  xorgcfg OR xorgconfig
	
	
	--
	Best regards,
	Chris
	
	Everybody who didn't want a pain shot when you were
	passing out pain shots wants one when you are passing
	out sleeping pills.