Linksys WPC11 v.4 problems in 5.2, 5.2.1 and 5.3-RC1

[jason]

Stephen P. Cravey wrote:

>I've just purchased a new 802.11b pcmcia card for a laptop and I'm
>getting errors when I insert it. Is this card not supported yet, other
>than debug sysctls, is there anythgin else I should check? Yes, i did
>add pccard_enable to rc.conf.
>
>I'm running 5.3-RC1 at the moment, but I have the same problem with
>5.2-R and 5.2.1-R. Since I have no network interface, I'm stuck with
>what I can install from CD.
>
>I've included (what I think is) the pertinent debugging info:
>
>
>
>Dmesg:
>cbb0: <TI1121 PCI-CardBUS Bridge> at device 7.0 on pci0
>cardbus0: <CardBus bus> on cbb0
>pccard0: <16-bit PCCard Bus> on cbb0
>
>Insert:
>cardbus0: <network, ethernet> at device 0.0 (no driver attached)
>cbb0: CardBus card activation failed
>
>Debug Insert:
>Status is 0x300000820
>cbb0: card inserted: event=0x00000000, state=30000820
>cbb0: cbb_power: 3V
>TUPLE: LINKTARGET [3]: 43 49 53
>Manufacturer ID: 00004c02
>Functions: Network Adaptor, Multi-Functioned
>Function Extension: 0102
>Function Extension: 0280969800
>Function Extension: 0200e1f505
>Function Extension: 040600e04c390010
>TUPLE: Unknown(0x1c) [2]: 02 ff
>cardbus0: Opening BAR: type=IO, bar=10, len=0100
>cardbus0: Opening BAR: type=MEM, bar=14, len=200
>CIS reading done
>cardbus0: Non-prefetchable memory at 88000000-880001ff
>cardbus0: IO port at 1000-10ff
>cardbus0: <network, ethernet> at device 0.0 (no driver attached)
>cbb0: cbb_power: 0V
>cbb0: CardBus card activation failed
>
>Debug Remove:
>Status is 0x30000026
>_______________________________________________
>freebsd-questions at freebsd.org mailing list
>http://lists.freebsd.org/mailman/listinfo/freebsd-questions
>To unsubscribe, send any mail to "freebsd-questions-unsubscribe at freebsd.org"
>
>  
>
check out man ndiscvt