routing question

[doug at safeport.com]

thank you

On Sat, 5 Jun 2004, Eric Crist wrote:

> You need to kill all the running dhclient processes, then try again.
> Usually, this can be done with:
>
> #killall -9 dhclient
>
> HTH
>
> Eric F Crist
> President
> AdTech Integrated Systems, Inc
> (612) 998-3588
>
>
>
> > -----Original Message-----
> > From: owner-freebsd-questions at freebsd.org
> > [mailto:owner-freebsd-questions at freebsd.org] On Behalf Of
> > doug at safeport.com
> > Sent: Saturday, June 05, 2004 11:29 AM
> > To: freebsd-questions at freebsd.org
> > Subject: routing question
> >
> >
> > I am trying to configure a wireless router so I am redefining
> > routes and IP address of my system. After booting dhclient
> > ep0 works fine. After messing around with the wireless router
> > I was just going back to my ethernet connection so I did:
> >
> >    ifconfig ep0 192.168.0.3 remove
> >    arp -da
> >    route flush
> >    dhclient ep0
> >
> > This returned immediatly without assigning an IP or route so
> > I just connected manually using ifconfig and route. There
> > must be something I did not clear out, but I can not figure
> > it out. Thanks for any ideas. This is on 4.10 if that makes
> > any difference.
> >
> > _____
> > Douglas Denault
> > http://www.safeport.com
> > doug at safeport.com
> > Voice: 301-469-8766
> >   Fax: 301-469-0601 _______________________________________________
> > freebsd-questions at freebsd.org mailing list
> > http://lists.freebsd.org/mailman/listinfo/free> bsd-questions
> >
> > To unsubscribe, send any mail to
> > "freebsd-questions-unsubscribe at freebsd.org"
> >
>
>

_____
Douglas Denault
http://www.safeport.com
doug at safeport.com
Voice: 301-469-8766
  Fax: 301-469-0601