Kernel Panic during install with 4.8 mini ISO
yussef at claygirl.org
Thu Jun 5 23:38:18 PDT 2003
before the kernel is loaded, when you're given 10 seconds, hit any key
besides enter, then type 'set hw.pcic.intr_path=1' without the quotes.
good luck. hope this works.
On Thu, 5 Jun 2003 22:11:18 +0100
"Chris Ward" <chris.p.ward at ntlworld.com> wrote:
> I'm seeing a kernel panic during boot of 4.8 mini ISO install CD,
> details below.
> Fault virtual addr = 0xeb902
> Fault code = supervisor read, page not present
> Instr Ptr = 0x8:0xc00eb807
> Stack Ptr = 0x10:0xc0843d6c
> Frame Ptr = 0x10:0xc0843d6c
> Code Seg = base 0x0, limit 0xfffff, type 0x1b, DPL0, pres 1, def32 1,
> gran 1 Proc eflags = interrupt enabled, resume, IOPL=0
> Current proc = 0 (swapper)
> IRQ mask = net tty bio cam
> Trap no = 12
> Just prior to this it was probing the VGA:
> pcio0: <unknown card> (vendor = 0x1039, dev = 0x7013) at 1.6 irq 10
> pcib2: <PCI to PCI bridge (vendor = 1039, device = 0001)> at device
> 2.0 on pci0
> pci1: <PCI bus> on pcib2
> pci1: <SIS model 6300 VGA-compatible display device> at 0.0
> pci_cfgintr_virgin: using routable interrupt 3
> <Kernel panic follows...>
> The kernel is unmodified from that of the ISO image.
> I'm guessing that I need to pass in some params to init the graphics
> card but being new to FreeBSD I'm not sure how to do this.
> Could somebody please point me in the right direction?
> freebsd-questions at freebsd.org mailing list
> To unsubscribe, send any mail to
> "freebsd-questions-unsubscribe at freebsd.org"
More information about the freebsd-questions