HP Netserver E60, SCSI question...

[Evren Yurtesen]

Hi,

I have a netserver with 4.8-stable installed.
Whatever I do the freebsd finds my scsi drives as 10mbyte/sn huh...
Any suggestions?

ahc0: <Adaptec aic7895 Ultra SCSI adapter> port 0x1000-0x10ff mem 
0xfc100000-0xfc100fff irq 5 at device 5.0 on pci0
ahc0: Using left over BIOS settings
aic7895C: Ultra Wide Channel A, SCSI Id=7, 32/253 SCBs
ahc1: <Adaptec aic7895 Ultra SCSI adapter> port 0x1400-0x14ff mem 
0xfc101000-0xfc101fff irq 5 at device 5.1 on pci0
ahc1: Host Adapter Bios disabled.  Using default SCSI device parameters
aic7895C: Ultra Wide Channel B, SCSI Id=7, 32/253 SCBs

da0 at ahc0 bus 0 target 1 lun 0
da0: <HP 36.4G ST336706LW HP04> Fixed Direct Access SCSI-2 device
da0: 11.626MB/s transfers (5.813MHz, offset 8, 16bit), Tagged Queueing 
Enabled
da0: 34732MB (71132960 512 byte sectors: 64H 32S/T 34732C)

sync tranfer rate mb/sn :40
initiate wide negotiation: yes
enable disconnection : yes
send start unit command : yes
enable writeback cache : n/c