Cy.Schubert at komquats.com
Wed Jun 10 03:40:15 UTC 2015
How would one go about cross compiling ports? Specifically I need to run
make configure for ntp for each supported architecture. Googling, I found
some doc here, http://ray-freebsd.blogspot.ca/2011/09/cross-compiling-ports-
for-freebsd.html, however it fails because it cannot find crt1.o.
Is there a way to tell ld(1) where crt1.o is?
Is there a documented or supported approach to cross-build ports without
completely configuring pourdiere for each architecture?
Cy Schubert <Cy.Schubert at komquats.com> or <Cy.Schubert at cschubert.com>
FreeBSD UNIX: <cy at FreeBSD.org> Web: http://www.FreeBSD.org
The need of the many outweighs the greed of the few.
More information about the freebsd-ports